Effects of the Micro/nanostructure of Electrospun Zein Fibres on Cells in Simulated Blood Flow Environment.

Naian Shen,Yue Zhang,Ali Raza,Liu Chang,Jin-Ye Wang
DOI: https://doi.org/10.1016/j.msec.2021.111900
2021-01-01
Materials Science and Engineering C
Abstract:In order to prevent thrombosis, reduce intima hyperplasia, and to maintain long-term patency after implantation of an artificial blood vessel, the formation of intact endothelial cells layer on an inner surface of graft is desirable. The present study aimed to improve endothelial cell adhesion by regulating the morphology of the inner surface of artificial blood vessels. Zein fibre membranes with three fibre diameters (small, ~100 nm; medium, ~500 nm; and large, ~1000 nm) were constructed by electrospinning. A flow chamber device was designed to simulate the blood flow environment. The morphology and adhesion of human umbilical vein fusion cells (EA.hy926) on the surface of the fibre membranes were studied under a shear stress of approximately 15 dynes/cm2. The results showed that oriented electrospun zein fibre surfaces with both medium- and large-diameter fibres can regulate the morphology of endothelial cells (EA.hy926), which are aligned by the fibre direction. The three fibre membranes improved the adhesion of endothelial cells significantly compared to that on the flat membrane. When the fibre direction was fixed parallel to the fluid direction, the medium-diameter oriented-fibre membrane could significantly improve the ability endothelial cells to resist shear stress, and there was a significant difference at 1, 2 and 4 h time points compared with the shear stress resistance on the small-diameter and large-diameter oriented-fibre membranes. When the fibre direction was perpendicular to the fluid direction, again the medium-diameter oriented-fibre membrane improved the ability of endothelial cells to resist shear stress significantly at 1 and 2 h time points. It was concluded that by changing the diameter and arrangement of electrospun fibres, cell morphology control and shear stress resistance can be achieved.
What problem does this paper attempt to address?