Abstract:This paper presents the development of a hybrid model for simulating a vertical U-tube geothermal heat exchanger under actual climate.The model consists of a 3D model representing a pair of U-tubes buried in symmetric boreholes and a supplementary 2D model that can be applied to real site scenarios.The temperature series at the wall of the borehole and initial soil temperatures at different depths derived from the simulation results of the 3D model serve as the input boundary conditions of the 2D model.Hence,the hybrid model shares the respective advantages of both subordinate models and therefore provides comprehensive simulation resuhs that span approximately 10 months at a slight cost in implementation complexity.Meanwhile,the model is limited by numerous assumptions such as the consistency between the ground surface and air temperatures and physical uniformity of the materials.Simulations were performed based on the conditions obtained at a real site in the city of Hangzhou.The simulation time range was June 12,2015,to March 17,2016,which covered an entire cooling,transition,and heating season.The collected data revealed that the soil within an effective radius of 2 m gained an absolute increase in internal energy of 0.292 MJ after the simulation.The relative increases in the internal energy and average temperature were 1.037 MJ and 0.28 K,respectively,compared to those affected only by climate,which indicated an unwanted accumulation of heat beneath the ground.Moreover,the temperature at a deeper soil depth showed a lag in phase behind that of a shallower depth.This lag was approximately 2 weeks between a point at the center of the entrance and exit of the U-tubes and a point 1 m below it.Moreover,the fluctuation patterns of the inlet/outlet fluid temperatures showed a significant shift from the air temperature toward the annual averages,which were-8.313 K in the cooling season and 9.077 K in the heating season.Finally,the temperature distribution among pipe-clusters at different depths showed that the heat accumulation mainly occurred at a depth greater than 7 m,and the accumulation was more severe at a shallower depth and at the corners of clusters.

Numerical Simulation on Heat Transfer Inside and Outside of Vertical Buried Pipes Based on Two-Model Order Reduction Methods

Numerical Simulation and Analysis on the Heat Transfer of the Vertical Ground Heat Exchanger in Hydrous Soil

Cylindrical surface model of ground source heat pump considering soil stratification

Numerical simulation and thermal analysis of ecological energy-saving ground source heat pump design

Fast Simulation of Dynamic Heat Transfer Through Building Envelope Via Model Order Reduction

A Simplified Semi-Numerical Model to Simulate a U-pipe Ground Heat Exchanger

A New Heat Transfer Model for Single U-pipe Ground Heat Exchanger

Numerical simulation of temperature field around buried pipes of ground source heat pumps based on mathematical models

Design and Factor Analysis of Buried Heat Exchangers

A Simplified Numerical Model as a Design Tool for Vertical Single U-Tube Ground Heat Exchangers

Numerical Investigations on Model Order Reduction to SEM Based on POD-DEIM to Linear/nonlinear Heat Transfer Problems

Numerical simulation study on heat transfer performance of double U-shaped buried pipe heat exchanger

Model-Based Intelligent Simulation Of Underground Heat Exchanger

A fast numerical approach for the horizontal ground heat exchanger

Parametric POD-Galerkin Model Order Reduction for Unsteady-State Heat Transfer Problems

Investigation into the Heat Transfer Models for the Hot Crude Oil Transportation in a Long‐buried Pipeline

Comparison between Numerical Simulation and Analytical Calculation of Heat Loss and Temperature Profile of Buried Pipes

Numerical Simulation and Linear Heat Source Integrated Model of Vertical Embedded Pipe for Ground Source Heat Pump

Heat transfer analysis of a multi-borehole heat exchanger of ground source heat pump systems

Hybrid 3D and 2D Numerical Models of Geothermal Heat Exchanger for Ground Source Heat Pump System

Reduced Order Modeling of Fluid Flow and Heat Transfer in Tube-Fin Heat Exchanger