Abstract:Fundamental experiments under high-temperature and high-pressure conditions are challenging, leading to a gap in research on the flame propagation process of ammonia/hydrogen fuel in fields such as internal combustion engines. To compensate for the lack of flame speed under engine-relevant conditions, the premixed flame propagation for ammonia/hydrogen fuel was numerically studied through a one-dimensional simulation model based on Cantera. The temperature and pressure at the end of the ideal compression process were calculated in an isentropic process. Sensitivity analysis of flame speed and calculations of typical radical concentrations and pollutant emissions in the flame were performed. The promoting effects of initial temperature (500 K-900 K), hydrogen ratio (0-50%), and equivalence ratio (0.8-1.5) on ammonia/hydrogen flame propagation and the inhibitory effects of initial pressure (2 MPa similar to 6 MPa) were quantified. Calculation results indicated that the initial pressure increase in the high-temperature atmosphere causes the flame speed to decrease by more than 60%. In contrast, the temperature increase in the high-pressure environment provides the flame speed increase with a factor of 5. Under high temperature and high pressure, the flame speed of ammonia/hydrogen increases by more than 3.4 times when the hydrogen ratio is 50% and the flame speed reaches its peak when the equivalence ratio is 1.1-1.2, with an improvement of 65.8%. Key elementary reactions R5, R22, R24, and R30 that significantly influenced flame propagation were identified. In addition, the research also revealed emission characteristics during ammonia/hydrogen premixed flame propagation. NO emissions in the flame could be reduced by 26.7% through an increment in initial pressure from 2 MPa to 6 MPa. As the equivalence ratio ranges from 0.8 to 1.5, the minimum NO emissions occur at an equivalence ratio of 1.4, reduced by 98.9%. However, an increase in NO emissions was observed by elevating the initial temperature from 500 K to 900 K, by 54.6%, and a gradual rise in the hydrogen ratio from 0 to 50% was linked to a significant increase in NO emissions within the flame, by 79.8%. In the practical application of ammonia/hydrogen fuel in premixed combustion mode, an equivalence ratio below 1.4 is advisable.

RANS simulations on combustion and emission characteristics of a premixed NH3/H-2 swirling flame with reduced chemical kinetic model

RANS simulations on combustion and emission characteristics of a premixed NH3/H2 swirling flame with reduced chemical kinetic model

Experimental and numerical study of combustion characteristics of non-premixed ammonia–hydrogen–air swirling flame with/without secondary air injection

Experimental and Numerical Study of Combustion Characteristics of Ammonia-Hydrogen-air Swirling Flame With/without Secondary Air Injection

Visualization and simulation study of ammonia blending with hydrogen as combustion application in lean-burn condition

Analysis of the NH3 blended ratio on the impinging flame structure in non-premixed CH4/NH3/air combustion

Revealing the NO Formation Kinetics for NH3/CH4 Blends Under Dual-Flame and Premixed Swirl Flame Configurations

An Experimental and Kinetic Modeling Study on NH3/air, NH3/H2/air, NH3/CO/air, and NH3/CH4/air Premixed Laminar Flames at Elevated Temperature

A Comprehensive Kinetic Modeling Study on NH3/H2, NH3/CO and NH3/CH4 Blended Fuels

Effects of Ammonia Addition on Combustion Characteristics in Partially-Premixed Swirling Ammonia/methane/air Flame

Experimental and Kinetic Modeling Study of Laminar Burning Velocities of NH3/air, NH3/H2/air, NH3/CO/air and NH3/CH4/air Premixed Flames

Numerical Investigation on the Flame Propagation Process of Ammonia/hydrogen Blends under Engine-Related Conditions

Modelling Ammonia-Hydrogen-Air Combustion and Emission Characteristics of a Generic Swirl Burner

Blow-Off Limits, Flame Structure, and Emission Characteristics of Lean Partially Premixed Swirl-Stabilized Flames with NH 3 /CH 4

NOx Emission Characteristics of Active Pre-Chamber Jet Ignition Engine with Ammonia Hydrogen Blending Fuel

A comparison between turbulent non-premixed jet flames of CH4 and the 50%NH3+50%H2 blend

Understanding of Combustion Characteristics and NO Generation Process with Pure Ammonia in the Pre-Chamber Jet-Induced Ignition System

Effects of Air-Staging and Heat Losses on NO Emissions of NH3/CH4/air Swirling Flames

Combustion and emission characteristics of a gasoline/ammonia fueled SI engine and chemical kinetic analysis of NOx emissions

Emission Characteristics and Heat Release Rate Surrogates for Ammonia Premixed Laminar Flames

Emission prediction and analysis on CH4/NH3/air swirl flames with LES-FGM method