Pyroelectric Polyvinylidene Fluoride Film Prepared by a Novel Combining Method and Its Application in Fully Flexible Infrared Detector

Ruilin Yang,Jimeng Li,Yang Wang,Yang Liu,Xiaosong Du,Weizhi Li

DOI: https://doi.org/10.1016/j.infrared.2020.103624

IF: 2.997

2021-01-01

Infrared Physics & Technology

Abstract:For the fabrication of pyroelectric polyvinylidene fluoride (PVDF) film with high performance, a novel method is presented which combines the usual two steps of solution casting and stretching into one. It demonstrates that a stretch ratio as large as 15 as well as low quantity of defects and high uniformity are achieved by this new technique. The characterization results reveal that baking temperature (T-b) after stretching has significant and similar influences on relative beta-phase fraction (F-beta), remnant polarization (P-r), dielectric constant and loss (epsilon' and epsilon '') and pyroelectric coefficient of the samples; the highest pyroelectric coefficient, occurring at baking temperature of 80 degrees C without thermal poling, is 12.4 mu C m(-2) K-1, which is larger than that of the usually-stretched sample undergoing thermal poling. In addition, by using the prepared film as sensitive element, a novel chopperless pyroelectric infrared detector is constructed by electrostatically modulating the incident thermal irradiation; the measurement results demonstrate that the detector has excellent pyroelectric voltage response to the thermal radiation of the laser source and hot (warm) water with a sensitivity of 2.65 x 10(4) V/W, showing its good potential for fully flexible infrared detector and temperature sensor.