Abstract:A lidar detects atmospheric parameters by transmitting laser pulse to the atmosphere and receiving the backscattering signals from molecules and aerosol particles. Because of the small backscattering cross section, a lidar usually uses the high sensitive photomultiplier and avalanche photodiode as detector and uses photon counting technology for collection of weak backscatter signals. Photon Counting enables the capturing of extremely weak lidar return from long distance, throughout dark background, by a long time accumulation. Because of the strong solar background, the signal-to-noise ratio of lidar during daytime could be greatly restricted, especially for the lidar operating at visible wavelengths where solar background is prominent. Narrow band-pass filters must therefore be installed in order to isolate solar background noise at wavelengths close to that of the lidar receiving channel, whereas the background light in superposition with signal spectrum, limits an effective margin for signal-to-noise ratio (SNR) improvement. This work describes a lidar prototype operating at the Fraunhofer lines, the invisible band of solar spectrum, to achieve photon counting under intense solar background. The photon counting lidar prototype in Fraunhofer lines devised was used to observe the atmospheric boundary layer. The SNR was improved 2-3 times by operating the lidar at the wavelength in solar dark lines. The aerosol extinctions illustrate the vertical structures of aerosol in the atmospheric boundary over Qingdao suburban during summer 2011.

An All-Day Lidar for Detecting Soft Targets over 100 Km Based on Superconducting Nanowire Single-Photon Detectors

Multi-Longitudinal-Mode High-Spectral-Resolution Lidar

Stratospheric aerosol lidar with a 300 µm diameter superconducting nanowire single-photon detector at 1064 nm

Micro-pulse Polarization Lidar at 15 Μm Using a Single Superconducting Nanowire Single-Photon Detector

Long-range Micro-Pulse Aerosol Lidar at 15 Μm with an Upconversion Single-Photon Detector

Photon counting lidar working in daylight

Single-photon imaging over 200 km

Long-range micro-pulse aerosol lidar at 1.5 um with an up-conversion single-photon detector

Single-photon Computational 3D Imaging at 45 Km

Photon-counting Chirped Amplitude Modulation Lidar System Using Superconducting Nanowire Single-Photon Detector at 1550-Nm Wavelength

Dual-Frequency Doppler Lidar for Wind Detection with A Superconducting Nanowire Single-Photon Detector

Lidar with Superconducting Nanowire Single-Photon Detectors: Recent Advances and Developments

Demonstration of Measuring Sea Fog with an SNSPD-based Lidar System

Mini-Scheimpflug Lidar System for All-Day Atmospheric Remote Sensing in the Boundary Layer.

High-resolution wide range dual-channel scheimpflug lidar for aerosols detection

Long-range micro-pulse aerosol lidar at 1.5 μm with an upconversion single-photon detector.

Long-range Laser Ranging Using Superconducting Nanowire Single-Photon Detectors

Long Range 3D Imaging Through Atmospheric Obscurants Using Array-Based Single-Photon LiDAR.

Super-resolution Single-Photon Imaging at 8.2 Kilometers

Fraunhofer Lidar Prototype in the Green Spectral Region for Atmospheric Boundary Layer Observations.

Kilometer-range, full-Stokes polarimetric imaging LiDAR using fractal superconducting nanowire single-photon detectors