Hydrogenation of CO 2 to Formic Acid Catalyzed by Co and Cu Single-Atom Catalysts Supported on MOF-808: A DFT Investigation
Nawarat Kusonjariyakun,Jirapat Santatiwongchai,Jittima Meeprasert,Warot Chotpatiwetchkul,Thana Maihom,Sareeya Bureekaew,Sarawoot Impeng
DOI: https://doi.org/10.1016/j.surfin.2024.105379
IF: 6.2
2024-11-10
Surfaces and Interfaces
Abstract:In this work, DFT-based calculations and microkinetic modeling were employed to investigate CO 2 hydrogenation to formic acid using H 2 over Co and Cu single-atom catalysts supported on MOF-808. We investigated two pathways: one without the introduction of a second H 2 molecule (pathway A) and another one with it (pathway B). Pathway B, which involves introducing the second H 2 molecule alongside the formate intermediate from the first step, exhibits significantly lower energy barriers (three times less) for the transformation into formic acid in the second step of CO 2 hydrogenation. Moreover, pathway B shifts the reaction thermodynamics from endergonic to exergonic, highlighting its kinetic and thermodynamic advantages. Notably, we observed formate intermediates with quasi-bidentate geometry alongside the prevalent bidentate chelating geometry. Cu 2+ -MOF-808 exhibits superior catalytic activity compared to Co 2+ -MOF-808, attributed to Cu's stronger preference for stabilizing the transition state in its square planar geometry through the Jahn-Teller effect, which is less effective in Co. Furthermore, our microkinetic modeling consistently confirms that Cu 2+ -MOF-808 outperforms Co 2+ -MOF-808 at lower temperature, with the rate of formic acid production depending on the concentration of H 2 . The desorption of formic acid is identified as the rate-determining step of the reaction, significantly impact overall efficiency.
chemistry, physical,physics, applied, condensed matter,materials science, coatings & films