Abstract:Mechanical defects are one of the main reasons of GIS equipment failure. However, there are no available detection devices and mechanical defects assessment methods for GIS mechanical fault diagnosis. Firstly, the mechanism of mechanical vibration of GIS is deeply studied in this paper. On the basis of the research on the source and detection method of GIS vibration signal, the vibration acceleration sensor is used as the sensor to develop the GIS vibration signal detection device. Secondly, the GIS mechanical vibration test platform is built in the laboratory, and the spring contact loose defect of the GIS bus connector is set up on the test platform. Then the vibration test of the GIS shell was carried out on the condition that the bus connector is normal and the connection of connector is loose using the self-developed vibration signal detection device. Finally, the vibration signal characteristics of normal and loose defect are extracted based on the spectrum analysis method. The connection state evaluation method and judgment basis of GIS bus connector are given. The result indicates that obvious vibration signal can be detected in GIS shell near insulator. In normal operation, the vibration signals in all directions to the GIS shell have the same characteristics that obvious vibration signals at 100Hz frequency as well as in the frequency range of 1000Hz-2000Hz can be found. In particular, the amplitude of vibration signal at 1400Hz is almost equal to that at 100Hz. When GIS bus connector has a loose contact, the amplitude of vibration signal is relative high and closely related to direction. Take the amplitude of 100Hz as the reference value, the ratio of amplitudes between 1400Hz and 100Hz can be regarded as the characteristic quantity indicating the connection state of bus connector. The connector can be convinced of loose contact while the ratio is larger than 2 or smaller than 0.5 inferring from the experimental data in laboratory.

Identification Method of Abnormal Contact Defect on GIS Conductor Base and Disconnector Contact Based on Ensemble Empirical Mode Decomposition

GIS Mechanical State Identification and Defect Diagnosis Technology Based on Self-Excited Vibration of Assembled Circuit Breaker

Partial discharge diagnosis by simultaneous observation of discharge pulses and vibration signal

Mechanical defect identification for gas‐insulated switchgear equipment based on time‐frequency vibration signal analysis

Mechanical Defects Diagnosis for Gas Insulated Switchgear Using Acoustic Imaging Approach

Condition Assessment Method of GIS Disconnector Based on Vibration- Thermal-Electrical Multi-Parameter Signal Characteristics

Bolt looseness fault diagnosis of GIS based on vibration signal amplitude

The Study of Vibration Diagnosis Method for Gis

Feature Fingerprint Extraction and Abnormity Diagnosis Method of the Vibration on the GIS

Research Of The Vibration Characteristics In Gis Disconnector Under Different Contact State

Research of Mechanical State Diagnosis Techniques in GIS Bus Connector Based on Mechanical Vibration

Transient Vibration Study of Gis Bus Based on Fem

GIS Mechanical Fault Diagnosis Method Based on Middle Time Mel Cepstrum Coefficient

Partial Discharge Detection and Defect Location Method in GIS Cable Terminal

Method for Insulation Defect Pattern Recognition of Gas Insulated Switchgear Based on Support Vector Machine Algorithm

Measurement of partial discharge pattern on typical defects in GIS

Mechanical State Detection of GIS Circuit BreakerBased on Vibration Characteristics

Partial Discharge Characteristics and Development Process of GIS Insulator with Diverse Defects

Statistical Feature Extraction Combined with Generalized Discriminant Component Analysis Driven SVM for Fault Diagnosis of HVDC GIS

Study On The Vibration Characteristics Of Gis'S Vertical Bus Under Fastening Bolts On Flange

Statistical Operators Calculation Of Partial Discharge On Floating Electrode Defect In Gis