Multi-fracture Nonuniform Initiation and Vertical Propagation Behavior in Thin Interbedded Tight Sandstone: an Experimental Study
Yushi Zou,Budong Gao,Shicheng Zhang,Xinfang Ma,Zhiyu Sun,Fan Wang,Changyin Liu
DOI: https://doi.org/10.1016/j.petrol.2022.110417
IF: 5.168
2022-01-01
Journal of Petroleum Science and Engineering
Abstract:Thin interbedded tight sandstone of Shanxi Formation in Ordos basin, China, contains mudstone interlayers and laminas universally, and exhibits ultra-low matrix permeability, low brittleness, and areal heterogeneity. The stimulation effectiveness of this formation depends largely on whether multiple hydraulic fractures (HFs) can initiate and penetrate into the multiple thin sandstone layers upward and downward. To clarify the multi-fracture growth behavior of such formation, multi-cluster fracturing experiment in the horizontal well was performed on specimens prepared from the sandstone-mudstone outcrops of Shanxi Formation based on a true triaxial fracturing simulation system. The influences of interlayer stress difference, mudstone thickness, fluid viscosity, pumping rate and the number of clusters were mainly analyzed through post-fracturing specimen splitting and pressure curve analysis. Results show that the difference of rock mechanical parameters between sandstone and mudstone is relatively large. When interlayer stress difference is less than 3 MPa, the mudstone layer cannot function as a barrier to restrain the vertical growth of HFs, and the essential mechanism causing HF height containment is mainly the opening of laminas or/and interfaces. By contrast, when the interlayer stress difference is equal to or greater than 3 MPa and the dimensionless thickness of mudstone is more than 0.4, the HF height tends to be restrained. Increasing the fluid viscosity or/and pumping rate can reduce filtration, and fa-cilitates HFs penetrating through the laminas or interfaces and consequently propagating into adjacent layers. It has been observed that when fluid viscosity reaches 100 mPa s (cross-linked gel) and pumping rate is 100 mL/ min, HFs can pass through the overlaying mudstones. However, uniform initiation of all clusters is difficult to achieve due to the low brittleness of sandstone and heterogeneity along the horizontal wellbore. The experi-mental results prove that temporary plugging within the wellbore using the plugging agent of appropriate particle size is necessary to create multiple HFs in such formation.