Abstract:Mobile edge computing (MEC) and millimeter wave (mmWave) communications are capable of significantly reducing the network's delay and enhancing its capacity. In this paper we investigate a mmWave and device-to-device (D2D) assisted MEC system, in which user A carries out some computational tasks and shares the results with user B with the aid of a base station (BS). We assume partial offloading model and the task can be partitioned into two portions: the first part is computed locally at user A, while the second part is transmitted to the BS and computed by the MEC server. The computational results are then sent to user B through a D2D link and via the link from the BS to user B, respectively. To support computation offloading, both the users and the BS are equipped with multiple antennas and employ analog and digital (A/D) hybrid beamforming. Moreover, we propose a novel two-timescale joint hybrid beamforming and task allocation algorithm to reduce the system latency whilst cut down the required signaling overhead. Specifically, the high-dimensional analog beamforming matrices are updated in a frame-based manner based on the channel state information (CSI) samples, where each frame consists of a number of time slots, while the low-dimensional digital beamforming matrices and the offloading ratio are optimized more frequently relied on the low-dimensional effective channel matrices in each time slot. A stochastic successive convex approximation (SSCA) based algorithm is developed to design the long-term analog beamforming matrices. As for the short-term variables, the digital beamforming matrices are optimized relying on the innovative penalty-concave convex procedure (penalty-CCCP) for handling the mmWave non-linear transmit power constraint, and the offloading ratio can be obtained via the derived closed-form solution. Simulation results verify the effectiveness of the proposed algorithm by comparing the benchmarks.

Flexible Sectorized MPAC Configuration for 5G OTA Testing

Over-the-Air Testing of 5G Millimeter-Wave System with Adaptive Beamforming

A Low-Cost and Efficient Single Probe Based MIMO OTA Measurement Method

Impact of Probe Coupling on Emulation Accuracy in Massive MIMO OTA Testing

Key issues and algorithms of multiple-input-multiple-output over-the-air testing in the multi-probe anechoic chamber setup

Efficient Probe Weighting for MIMO OTA Testing Based on Douglas-Rachford Splitting Method

Robustness Analyses of 3D Probe Configuration for Different Channel Models in MIMO OTA Setups

Experimental Evaluation of User Influence on Test Zone Size in Multi-Probe Anechoic Chamber Setups

Accuracy Comparisons of Channel Emulation Methods for Two-dimensional Uniform and Three-dimensional Sectored Multi-probe Anechoic Chamber

An efficient multi‐probe enabled midfield over‐the‐air test method for 5G base station antenna pattern reconstruction

MIMO performance enhancement of MIMO arrays using PCS-based near-field optimization technique

Accuracies of Channel Emulation Methods for Sectored Multi-probe Anechoic Chamber

Latency Minimization for Mmwave D2D Mobile Edge Computing Systems: Joint Task Allocation and Hybrid Beamforming Design.

Three-Dimensional Spatial Multiplexing For Directional Millimeter-Wave Communications In Multi-Cubicle Office Environments

Comparisons of Channel Emulation Methods for State-of-the-Art Multi-Probe Anechoic Chamber Based Millimeter-Wave Over-the-Air Testing

Over-the-Air Radiated Testing of Millimeter-Wave Beam-Steerable Devices in a Cost-Effective Measurement Setup.

Test Zone Validation for FR2 MPAC Using Directional Antenna Based Virtual Array

On Simplifying WINNER II Channel Model for MIMO OTA Performance Evaluation

A Review of Over-the-Air Testing Methods for Performance Measurement of Antennas and Devices in Communication Systems

Multiprobe-Enabled Over-the-Air Calibration of Millimeter-Wave Antenna Arrays: Concepts and experimental validations

Multifunctional Frequency Selective Absorber Enabling FR1 and FR2 5G OTA Tests in a Hybrid Reverberation Chamber