Abstract:Lightning impulse voltage is one of the main causes of transformer breakdown in power system and also the key factor in determining its insulation structure. The optimization of electric field distribution under lightning impulse is the key point of insulation design of dry-type transformer. In this paper, the electric field distribution of 110 kV dry-type transformer was analyzed and optimized based on a field-circuit coupled way. First, considering the symmetry of the dry-type transformer structure, a two-dimensional axisymmetric finite element analysis model was established. The equivalent circuit of high voltage winding was built up in MATLAB Simulink toolbox by using the circuit parameters calculated according to the structure of transformer. Then the voltage distribution can be obtained by applying the lightning impulse waveform with a peak value of 480 kV to the circuit. After importing the voltage data, the electric field distribution can be calculated by finite element analysis software. Finally, on the basis of the initial scheme, the electric field of air channel were further optimized by increasing air channels and adjusting winding arrangement, so as to make the insulation design safer and more reliable. The results show that due to the existence of distribution parameters and the characteristics of short duration and high frequency of impulse voltage, its distribution in windings was characterized by nonuniformity, hysteresis and oscillation. For the initial scheme, the maximum electric field of the air channel of transformer appeared at 127 gs with a value of 5.84 kV/mm. After optimization, the electric field of transformer air channel was lower than 3 kV/mm in most time, and the maximum value was 3.46 kV/mm, which appeared at 10 gs.

Study of Comparison of Voltage Distribution in Transformer under Different Lightning Impulse Voltages

Study on Partial Discharge Characteristics in Transformer Based on Oscillating Lightning Impulse Voltage Waveforms

Voltage Distribution Characteristics of Transformer Winding under Different Type Impulse Voltage Waveform

Effect of Oscillation Frequency on the Breakdown Characteristics of Transformer Oil in a Highly Nonuniform Field under Lightning Impulse Voltage

Partial Discharge Measurement and Analysis of Transformer under Oscillating Lightning Impulse Voltage

Breakdown Characteristics of Transformer Oil under Oscillating Lightning Impulse in a Highly Non-Uniform Electric Field

Research on Transient Electric Field Distribution of High-Frequency Transformers Based on COMSOL and SIMULINK Co-simulation

Simulation and Analysis of Electromagnetic Properties at the Secondary Port of Electronic Current Transformers Under Very Fast Transient Overvoltage

The oil-paper insulation breakdown characteristics under non-standard lightning impulse voltages

Transient Voltage Distribution Characteristics of Ultrahigh-Voltage Transformer Windings under Impulses with Different Front Time

Voltage-time Characteristics of the Different Cellulose Particle Content Transformer Oil in A Highly Nonuniform Field under Lightning Impulse

Breakdown Characteristics of Oil-Paper Insulation under Lightning Impulse Waveforms with Oscillations

On Site Oscillating Lightning Impulse Test and Insulation Diagnose for Power Transformers

Dependence Of The Impulse Strength Of Typical Insulation Structures In Oil-Immersed Transformer On Waveshapes

Electric Field Optimization of Cast Resin Dry-Type Transformer under Lightning Impulse

Study on lightning impulse voltage distribution and Transfer Overvoltage of 500kV transformer

Measurement and Analysis of Transient Overvoltage Distribution in Transformer Windings Based on Reduced-Scale Model

Analysis of lightening impulse response of cast resin dry-type transformer

Turn-to-turn Insulation Breakdown Characteristics under Non-Standard Lightning Impulse Voltages

Numerical Analysis Of Lightning Transient Voltage Distributions In Hv Converter Transformer Winding

Breakdown Characteristics of Transformer Oil in a Uniform Field under Oscillating Impulse Voltage