Abstract:Background: Clinical monitoring of planar pressure is vital in several pathological conditions, such as diabetes, where excess pressure might have serious repercussions on health of the patient, even to the extent of amputation. Objective: The main objective of this paper is to experimentally evaluate the combined application of the Fibre Bragg Grating (FBG) and the lead zirconate titanate (PZT) piezoceramic sensors for plantar pressure monitoring during walk at low and high speeds. Methods: For fabrication of the pressure sensors, the FBGs are embedded within layers of carbon composite material and stacked in an arc shape. From this embedding technique, average pressure sensitivity of 1.3 pm/kPa and resolution of nearly 0.8 kPa is obtained. These sensors are found to be suitable for measuring the static and the low-speed walk generated foot pressure. Simultaneously, PZT patches of size 10 × 10 × 0.3 mm were used as sensors, utilizing the d<formula>_{33}</formula> (thickness) coupling mode. A sensitivity of 7.06 mV/kPa and a pressure resolution of 0.14 kPa is obtained from these sensors, which are found to be suitable for foot pressure measurement during high speed walking and running. Both types of sensors are attached to the underside of the sole of commercially available shoes. In the experiments, a healthy male subject walks/runs over the treadmill wearing the fabricated shoes at various speeds and the peak pressure is measured using both the sensors. Commercially available low-cost hardware is used for interrogation of the two sensor types. Results: The test results clearly show the feasibility of the FBG and the PZT sensors for measurement of plantar pressure. The PZT sensors are more accurate for measurement of pressure during walking at high speeds. The FBG sensors, on the other hand, are found to be suitable for static and quasi-dynamic (slow walking) conditions. Typically, the measured pressure varied from 400 to 600 kPa below the forefoot and 100 to 1000 kPa below the heel as the walking speed varied from 1 kilometer per hour (kmph) to 7 kmph. Conclusions: When instrumented in combination, the two sensors can enable measurements ranging from static to high speed conditions Both the sensor types are rugged, small sized and can be easily embedded in commercial shoes and enable plantar pressure measurement in a cost-effective manner. This research is expected to have application in the treatment of patients suffering from diabetes and gonarthrosis.

ASSESSING THE POTENTIAL INFLUENCE OF DIFFERENT WALKING STRATEGIES ON PLANTAR PRESSURE DISTRIBUTION TRIGGERED BY A PORTABLE BIOFEEDBACK-BASED GAIT TRAINING DEVICE

Biofeedback-Informed Walking Strategy for Partial Foot Unloading in Able-Bodied Subjects

Elevated plantar pressure in diabetic patients and its relationship with their gait features

Analysis of Diabetic Foot Deformation and Plantar Pressure Distribution of Women at Different Walking Speeds

Research of Foot Plantar Pressure Scanning System Design Based on Sensor Array

Plantar Pressure Variability and Asymmetry in Elderly Performing 60-Minute Treadmill Brisk-Walking: Paving the Way towards Fatigue-Induced Instability Assessment Using Wearable In-Shoe Pressure Sensors

Center of Mass Motion and Plantar Pressure Distribution during Walking in Overweight Individuals

Effect of Plantar Pressure on Stepping Friction under Cross‐slope Condition

Combined application of FBG and PZT sensors for plantar pressure monitoring at low and high speed walking

Design and analysis of plantar hydraulic control device for body weight support treadmill training

Flexible sensor matrix film-based wearable plantar pressure force measurement and analysis system

The effect of calcaneus and metatarsal head offloading insoles on healthy subjects' gait kinematics, kinetics, asymmetry, and the implications for plantar pressure management: A pilot study

Research progress on plantar pressure of diabetic patients

Design and Preliminary Validation of Individual Customized Insole for Adults with Flexible Flatfeet Based on the Plantar Pressure Redistribution

Clinical Applications of Plantar Pressure Measurement

Integrated Fibrous Iontronic Pressure Sensors with High Sensitivity and Reliability for Human Plantar Pressure and Gait Analysis

Design of a Plantar Pressure Insole Measuring System Based on Modular Photoelectric Pressure Sensor Unit

Clinical foot measurements as a proxy for plantar pressure testing in people with diabetes

Plantar Pressure Analysis of Above-Knee Amputee with a Developed Microprocessor-Controlled Prosthetic Knee

Study on Plantar Pressure in Diabetic Patients

Study on plantar pressure in community diabetic patients