Dielectric Properties of SiO2/MMT/LDPE Micro-nano Composites

Hongtao Jiang,Xiaohong Zhang,Junguo Gao,Ning Guo

DOI: https://doi.org/10.1109/ichve49031.2020.9279624

2020-01-01

Abstract:Low-density polyethylene is one of the most comprehensive used as insulation materials in the power equipment. How to improve dielectric properties by doping inorganic particles in LDPE has always been concerned by many researchers. In this paper, SiO 2 particles and MMT particles were added to LDPE, the order of adding particles was changed, and different micro-nano composites was made. The crystallization characteristics of composites were analyzed, and the εr and tanδ changes of each material were investigated with frequency and temperature. The results of crystallization show that the crystalline properties and crystallinity of the composites are higher than the matrix LDPE, the addition of SiO 2 particles increases the composites' crystallinity significantly, the intercellular spacing of micro-nano composites is the smallest among all materials, and adding order in first small size particles and then large size particles is beneficial to the combination of each particle in matrix, composites' crystal structure become more tight and crystallinity of composites raise. Experimental data of dielectric frequency spectra show that the dielectric constants of micro-nano composites and composites added MMT particles are lower than the matrix, the addition of MMT particles can raise the composites' dielectric loss, however the dielectric loss of SiO 2 -MMT/LDPE composites prepared by adding small size particles first and large size particles later is the lowest among all composites. The experimental data of dielectric temperature spectra show that the permittivity of SiO 2 -MMT/LDPE is still at a low level under temperature conditions. The results show that the crystallization and dielectric properties of SiO 2 -MMT/LDPE micro-nano composites can be improved by the method of adding small size particles first and large size particles later, and the adding method can limit molecular chain movement and establish the polarization difficultly, however it also can destroy the original interface area and reduce the ability to bind chains to the thermal motion of molecules.