Abstract:This paper proposes an algorithm for robotic kinematic calibration based on a minimal product of exponentials (POE)-based model for the applications where only position measurements are required. Both joint zero-offset errors and initial frame twist error can be involved in this model. Analysis of the identifiability of these errors shows that at most six elements of these parameters can be identified. It also suggests that at least three noncollinear points on the end-effector should be measured to maximize the identifiability. Compared with the traditional POE-based model with full pose (position and orientation) measurements, the minimal model with only position measurements outperforms in terms of convenience, efficiency, and accuracy.Note to Practitioners-Kinematic calibration is pivotal to improve the position accuracy of a robot. To avoid the disadvantages of measuring the orientation of the end-effector during calibration, an algorithm using only position measurements is presented, with which one needs only position measurements of several points fixed on the end-effector without orientation information during the whole calibration process. This will greatly facilitate the scheme design as well as the practical operations. The identifiability of the parameters is then analyzed with two conclusions: 1) at most six elements of the joint zero-offsets and the initial frame twist in total can be identified simultaneously and 2) at least three points on the end-effector which are not collinear should be measured so as to make the identifiability maximum. According to these conclusions, one should carefully select parameters to formulate the error model and measure sufficient points on the end-effector during the calibration procedure.

Elasto-geometrical calibration of six-DOF serial robots using multiple identification models

An Enhanced POE-Based Method with Identified Transmission Errors for Serial Robotic Kinematic Calibration.

Separable Nonlinear Least Squares Algorithm for Robust Kinematic Calibration of Serial Robots.

Calibration of 6-DOF Parallel Mechanism Using Joint Force Sensors

A Robot Calibration Method Based on Joint Angle Division and an Artificial Neural Network

A Two-Stage Parameter Identification Method and Compensation Verification for Heavy Load Robot

Pose Error Compensation Based on Joint Space Division for 6-DOF Robot Manipulators

An Improved Kinematic Model for Serial Robot Calibration Based on Local POE Formula Using Position Measurement

Kinematic-Parameter Identification for Serial-Robot Calibration Based on POE Formula

Experimental Analysis on the Effectiveness of Kinematic Error Compensation Methods for Serial Industrial Robots

Determination of the Identifiable Parameters in Robot Calibration Based on the POE Formula

Positioning error calibration of six-axis robot based on sub-identification space

A Minimal POE-Based Model for Robotic Kinematic Calibration with Only Position Measurements

Model-based kinematic and non-kinematic calibration of a 7R 6-DOF robot with non-spherical wrist

A general and novel approach for parameter identification of 6-DOF parallel kinematic machines

Inverse Kinematics of 6R Robots Based on the Orthogonal Character of Rotation Sub-matrix

Geometric and Stiffness Modeling and Design of Calibration Experiments for the 7 dof Serial Manipulator KUKA iiwa 14 R820

Simultaneous Calibration of Multicoordinates for a Dual-Robot System by Solving the AXB = YCZ Problem

Dynamics Parameter Identification of Articulated Robot

Efficient Model-Free Calibration of a 5-Degree of Freedom Hybrid Robot

An Efficient Kinematic Calibration Method for Parallel Robots With Compact Multi-Degrees-of-Freedom Joint Models