Abstract:This study investigated the two-stage ignition behavior of NH 3 /H 2 mixtures using a rapid compression machine (RCM). The ignition delay times and first-stage ignition delay times of NH 3 /H 2 blends were measured at temperatures ranging from 881 to 1127 K, pressures of 15 and 25 bar, and equivalence ratios ( & phi;) of 1.0 and 1.5. Experimental results showed that H 2 had a significant promotional effect on the ignition of NH 3 , and two-stage ignition behavior was observed in some test mixtures. Time-resolved species concentrations were recorded using the gas chromatography (GC) method during the single- and two-stage ignition process. Species evolution suggested that the consumption of NH 3 and H 2 separated during the two-stage ignition process. The oxidation of H 2 primarily occurred at the first-stage ignition point, while NH 3 oxidation occurred at the total ignition point. A kinetic model was developed to predict the twostage ignition behavior of NH 3 /H 2 and the species profiles. Model analysis showed that H 2 played a key role in initiating the oxidation process and contributed to the early heat release. When H 2 content was high (e.g. 50%), its oxidation led to the simultaneous total oxidation of NH 3 , resulting in single-stage ignition characteristics. However, when a small amount of H 2 was present (e.g. 10%), its oxidation only partially consumed NH 3 , leading to the two-stage ignition behavior. Sensitivity analyses indicated that the co-oxidation of fuels during the first-stage ignition was primarily dominated by H 2 oxidation chemistry, while NH 3 oxidation became dominant during the following total ignition stage as H 2 was completely consumed. Additional model simulations revealed that the ignition behavior of NH 3 /H 2 mixtures is strongly influenced by temperature and pressure. A distinct threshold for temperature and pressure was identified, demarcating the transition between single-stage and two-stage ignition phenomena. Moreover, the fraction of H 2 in the mixture had a significant impact on the ignition behavior, with higher fractions leading to increased intensity of the first-stage ignition and closer proximity to the total ignition point. However, when the H 2 fraction exceeds a certain threshold, two-stage ignition behavior disappears.& COPY; 2023 The Combustion Institute. Published by Elsevier Inc. All rights reserved.

The Auto-Ignition Behaviors of HMX/NC/NG Stimulated by Heating in a Rapid Compression Machine

The Auto‐Ignition Behaviors and Thermal Safety of the Composite Modified Double Base Propellants under Rapid Heating

Auto-Ignition Behaviors of the Composite Modified Double Base Propellants

Auto-ignition Behaviors of Nitromethane in Diluted Oxygen in a Rapid Compression Machine: Critical Conditions for Ignition, Ignition Delay Times Measurements, and Kinetic Modeling Interpretation.

Investigation of Methanol Ignition Phenomena Using a Rapid Compression Machine

The Auto-Ignition Behaviors and Risk Assessments of Double-Base Propellant Containing Different 1,1-Diamino-2,2-dinitroethene Particle Sizes under Rapid Heating

Chemical Insights into the Two-Stage Ignition Behavior of NH3/H2 Mixtures in an RCM

Simultaneous Lateral- and End-View Visualization of the Auto-Ignition of Primary Reference Fuels in a Rapid Compression Machine

Experimental investigation of auto-ignition of ethylene-nitrous oxide propellants in rapid compression machine

Ignition Characteristics of Dual-Fuel Methane-N-hexane-oxygen-diluent Mixtures in a Rapid Compression Machine and a Shock Tube

Auto-ignition Characteristics of End-Gas in a Rapid Compression Machine under Super-Knock Conditions

Experiments and Modeling of the Autoignition of Methylcyclohexane at High Pressure

Direct Modeling of Auto-Ignition and Flame Propagation of N-heptane-Air Mixtures at HCCI Conditions by Using Dynamic Multi-Timescale Method

Reaction propagation, leading to developing detonation, in a rapid compression machine

A Study on the Effect of Initial Temperature on Combustion Characteristics of RDX Based on the Optical Diagnosis Methods

Experimental And Kinetic Modeling Study On Self-Ignition Of Alpha-Methylnaphthalene In A Heated Rapid Compression Machine

Investigating Autoignition Characteristics of Ammonia/Heptamethylnonane Mixtures over Wide Pressure Ranges: Rapid Compression Machine Measurements and Kinetic Modeling Study

Shock Wave and Flame Front Induced Detonation in a Rapid Compression Machine

Temperature Non-Uniformity and Its Effects on Auto-Ignition in a Rapid Compression Machine

Experimental and Kinetic Modeling Study on Self-Ignition of α-Methylnaphthalene in a Heated Rapid Compression Machine

An Experimental Investigation on Two-Stage Low-Temperature Heat Release in Iso-Octane Auto-Ignition