Abstract:In recent years, there has been widespread interest in the design of microair vehicles (MAVs) for flapping flight with high-aspect ratio wings due to their high efficiency and energy savings. However, the flexibility of a flapping wing causes the aeroelastic effect, which remains a subject of investigation. Generally, existing research simulates active bending and twisting of flexible wings under the assumption of neglecting flapping inertia. In this research, the kinematic optimization of a bionic wing with passive deformation in forward flight while undergoing flapping and pitching is considered. To this end, a computational aeroelasticity framework, which includes the three-dimensional unsteady vortex lattice method (UVLM) and the Newmark-β method, is constructed for flapping flight. Under the assumption of linear elastic deformation, this tool is capable of simulating attached flows over a thin wing and capturing unsteady effects of wakes. A bionic numerical wing with an aspect ratio of 6.5, chord Reynolds number of 1.9 × 105, and reduced frequency less than 0.1 is investigated in kinematic optimization. The computational aeroelasticity framework is combined with a global optimization algorithm to identify the optimal kinematics that maximize the propulsive efficiency under the minimum average lift constraint. Two types of numerical wings, rigid wing and flexible wing, are considered here to compare the influence of deformation on the aerodynamics of the flapping wing. The results show that the aeroelastic effect, which increases the flapping amplitude, yields a significant improvement in terms of propulsive efficiency. In addition, the optimization algorithm maximizes the thrust efficiency while satisfying the required lift. Moreover, the optimal kinematics of both the rigid wing and the flexible wing reach the maximum flapping angle, which indicates that a larger range of motions is needed for optimal kinetics when loosening the boundary conditions.

Flexible Multibody Modeling and Analysis of Prebending Leading-Edge Slats

Modeling and Simulation of Flexible Multi-Body Dynamics for Large Aircraft Components Alignment Mechanism

Modified Fourier-Galerkin Solution For Aerospace Skin-Stiffener Panels Subjected To Interface Force And Mixed Boundary Conditions

Increment Frictional Loading Analysis for High-Lift Devices with Seals

A New X-Actuator Design for Controlling Wing Bending and Twisting Modes

A Shear-Sliding Rigid-Flexible Coupled Skin Variable-Sweep Wing Design and Heat-Fluid-Structure Multifield Coupling Analysis

A NEW X-ACTUATOR DESIGN FOR DUAL BENDING/TWISTING CONTROL OF WINGS

An efficient stiffness analysis model based on shear deformation theory for flexible skin shear variable-sweep wing

Kinematic Optimization of a Flexible Wing Undergoing Flapping and Pitching

A Methodology for Modeling and Simulating Frictional Translational Clearance Joint in Multibody Systems Including a Flexible Slider Part

Study of Dynamic Interaction Between Low Re Aerodynamic Load and Flexible-Biomimetic Wings with Tailorable Stiffness by FSI Modeling

Dynamics for rigid–flexible coupled solar panel multibody system composed of composite laminated plates

Design and dry wind tunnel test of progressive flexible variable bending wing

Modeling and Analysis of Flexible Deployable Structure with Scissor-Like Elements Using a Novel Non-Locking Beam Element

Dynamic CFD/CSD Coupling Research for Flexible Micro Aircraft

Control-Oriented Modeling for Flexible Aircraft

Aerodynamic performance of flexible flapping wings deformed by slack angle

Fluid-structure interaction simulation for multi-body flexible morphing structures

Modulation of leading edge vorticity and aerodynamic forces in flexible flapping wings

Research on Adaptive Flexible Wing with Variable Trailing Edge

Analysis of nonlinear aerodynamic performance and passive deformation of a flexible flapping wing in hover flight