Numerical simulation and experimental verification of effect of CO2 enrichment on flow field of greenhouse

Liu Yanhua,Zeng Zhixiong,Guo Jiaming,L Enli,Meng Qinglin
DOI: https://doi.org/10.11975/j.issn.1002-6819.2015.12.026
2015-01-01
Abstract:Carbon dioxide (CO2) is one of the important raw materials for photosynthesis of crops in greenhouse, which can increase the harvest of the crops. In order to analyze the performance of CO2 fertilizer enrichment, this paper took indoor environment of greenhouse as the research object, and by means of unstructured mesh generation method, a two-dimensional turbulence computational model of greenhouse was built by ICEM CFD (the integrated computer engineering and manufacturing code for computational fluid dynamics) technique. After building 7532 triangle/quadrangle meshes, the skewness of mesh model was less than 0.75. To solve two-dimensional computational model of greenhouse, the CFD software FLUENT and the SIMPLE algorithm were used. Meanwhile, the porous model, the DO (discrete ordinates) model and thek-ε model were adopted. Governing equations of finite volume method were employed, including mass, momentum and energy conservation equations. In computational model, CO2 enriching inlet was set with the condition of mass flow inlet while outlet was set with the condition of pressure outlet through pre-calculation. And crop area was defined as porous material with the porosity of 0.8. Adopting steady-state solver to operate, environmental parameters such as indoor temperature, nitrogen (N2) concentration, oxygen (O2) concentration and CO2concentration should be initialized when flow field of greenhouse was stable. Then transient solver was needed to numerical simulation when acceleration of gravity was 9.8 m/s2 and step size was 0.01 s. By such methods, the effects of CO2jetting height, enriching flow speed and other factors on CO2 enrichment property were computed while the change of CO2concentration and distribution regularities were studied. After the simulations, some results were obtained. CO2 enrichment process had little effect on temperature of crop area, and both temperature distribution and air velocity distribution of crop area were uniform. As CO2 enrichment process lasted only for 5 min and solar radiation affected indoor environment of the greenhouse rarely, the temperature difference in the crop area was less than 0.5℃. On the other hand, cooler air was more likely to deposit to the bottom of the greenhouse and hotter air exhausted from wet curtain because of density difference of air flow. With the influence of buoyancy lift and newly added flow, air velocity of bottom side was higher. And the biggest velocity of air flow appeared in the area between jetting nozzle and bottom side of the greenhouse. Molar mass of CO2is greater than O2 and N2. And as a result of deposition effect of CO2, the bottom of the greenhouse had a higher CO2concentration while CO2 concentration in upper part was less, which helped the photosynthesis of crops. Moreover, CO2flowed to the exit of the greenhouse via bottom side. In crop area, CO2concentration was higher when closing to entrance. Although there was nearly no different in first 30 s, CO2jetting height had a certain effect on CO2enrichment time. CO2 concentration could be decreased when CO2jetting height was located at a high level. When jetting height was higher, spreading range of CO2was larger, CO2 deposited in crop area was less and CO2concentration was lower. However, CO2 concentration of crop area would be increased too fast when jetting height was too low. With the increase of CO2 enrichment flow, CO2concentration increased and CO2 enrichment time decreased. CO2 enrichment flow had a certain effect on CO2 enrichment time in crop area. Thus, transforming enrichment flow or time could control CO2concentration of the greenhouse which benefited photosynthesis of crops. A test was made to verify the accuracy of the numerical model. The simulation values and test values of CO2concentration at the same moment were in good agreement, and the biggest difference between them was less than 5%, which demonstrated that such models were correct. Result of this paper reveals the CO2 enrichment rules and the characteristics of flow field in greenhouse, which has a certain reference for the design and optimization of CO2 enriching equipments in greenhouse.
What problem does this paper attempt to address?