Abstract:The Raman shift of the nu(3)(SiO4) mode of zircon at -1008 cm(-1) has been observed to vary with the pressure (P) and temperature (7) of the environment. The relationship between the nu(3)(SiO4) peak position and P-T was calibrated in previous work and used to develop a pressure sensor for high P-T experiments, up to 1000 degrees C and 10 GPa, to an accuracy within +/- 50 MPa. This pressure measurement method is valid for zircon grains for which the nu(3)(SiO4) Raman shift occurs specifically at or close to 1008.17 cm(-1) at room temperature (25 degrees C). However, the peak position of nu(3)(SiO4) for some zircon grains may shift to a lower or higher wavenumber under ambient conditions, mainly due to the chemical composition of the grains. This may cause substantial deviation in the measured pressures. In the present study, we recalibrated the pressure sensor by determining the position of the nu(3)(SiO4) peak for zircon grains with different chemical compositions at given P-T conditions and developed a model applicable to both natural and synthetic zircon samples. All the zircon samples considered were found to have a universal nu-T relationship when the nu(3)(SiO4) wavenumbers under ambient conditions were calibrated to the same position. Based on this relationship, the temperature-induced wavenumber shift of nu(3)(SiO4) can be expressed as Delta nu(T) (cm(-1)) = 8.00 x 10(-9) x (T-3 - T-o(3))- 2.00 x 10(-5) x (T2 - T-o(2))- 2.78 x 10(-2) x (T - T-o), where T and T-0 are the target and room temperatures, respectively. In addition, the pressure-induced wavenumber shift of nu(3)(SiO4) can be calculated using Delta nu(P) (cm(-1)) = Delta nu - Delta nu(T), where Av is the total frequency shift between the target and ambient P-T conditions. By the linear regression of the experimental results, the global slope (partial derivative nu/partial derivative P)(T) was determined to be 5.91 x 10(-3) cm(-1)/MPa. In addition, high P-T experiments performed in isochoric systems using a hydrothermal diamond anvil cell (HDAC) showed that the cross-derivative term (partial derivative(2)nu/partial derivative P partial derivative T) was equal to zero, which is the same as the previous study. The revised method was used to determine the pressures inside a fused silica capillary capsule (FSCC) containing a NaCl solution. The pressures determined from the zircon Raman spectra (P-zr) were compared with those calculated using the equation of state (P-Eos) of a NaCl-H2O system. The determined P-Zr and P-Eos values agreed well for temperatures lower than similar to 500 degrees C. However, P. was significantly lower than P-Eos at higher temperatures due to the thermal expansion of the FSCC, i.e., the expansion of the sample chamber under the high internal pressures when the silica glass softened at high temperatures. The revised method was programmed in a Microsoft EXCEL spreadsheet and is presented in the Appendix B.

POTENTIAL GEOLOGICAL BAROMETER:NEW METHOD TO DETERMINE THE PRESSURE WITH DAUGHTER MINERALS IN FLUID INCLUSION BY RAMAN SPECTROSCOPY

In Situ Raman Spectroscopic Study of Barite As a Pressure Gauge Using a Hydrothermal Diamond Anvil Cell

Principle and Geological Applicability of the Raman Elastic Geothermobarometry for Mineral Inclusion Systems

Determining Pressure with Daughter Minerals in Fluid Inclusion by Raman Spectroscopy:Sphalerite As an Example

A New Method for Measurement of Internal Pressure of Inclusions:CO2-Raman Spectrometry

Determination of Pressure from Measured Raman Frequency Shifts of Anhydrite and Its Application in Fluid Inclusions and HDAC Experiments

Raman Spectra Based Pressure Calibration of the Non-Gauge Sapphire Anvil Cell at High Temperature and High Pressure

Review on Application of Optical Scattering Spectroscopy for Elastic Wave Velocity Study on Materials in Earth's Interior]

STUDY OF PRESSURE GAUGE FOR FLUID INCLUSIONS: RAMAN SPECTROSCOPY OF NA_2SO_4SOLUTION AT HIGH TEMPERATURE AND HIGH PRESSURE

Determination of Inner Pressure for Fluid Inclusions by Raman Spectroscopy and Its Application

A Novel Method for Pressure-Density-temperature-composition Reconstruction of Water-Bearing CO2/CH4-rich Geofluids Based on a High-Precision Raman Calibration Model

In-situ Raman study and phase transition of gypsum under high pressure

The Application of Laser Raman Spectroscopy to Obtaining Internal Pressure of Fluid Inclusions

A method for simultaneous measurements of compressional wave and shear wave velocities in rocks and minerals at high pressure and high temperature: A modification to the combined transmission-reflection method

Fossil Pressures of Fluid Inclusions in Mantle Xenoliths Exhibiting Rheology of Mantle Minerals: Implications for the Geobarometry of Mantle Minerals Using Micro-Raman Spectroscopy

Experimental study on the stability of oxalic acid and carbon dioxide manometer.

The Temperature Dependence of Raman Intensity of Aqueous Species (SO42− and H3PO40): Implication for in Situ Fluid Composition Investigation at Elevated Temperature

Reassessment of the Zircon Raman Spectroscopic Pressure Sensor and Application to Pressure Determination of Fused Silica Capillary Capsule

In Situ Raman Spectroscopic Quantification of CH 4 –CO 2 Mixture: Application to Fluid Inclusions Hosted in Quartz Veins from the Longmaxi Formation Shales in Sichuan Basin, Southwestern China

Hydrostaticity of pressure-transmitting media for high pressure infrared spectroscopy

Raman spectroscopic densimeter for pure CO2 and CO2-H2O-NaCl fluid systems over a wide P-T range up to 360 °C and 50 MPa