Effect of water vapour and H 2 S content on the hydrogen embrittlement sensitivity of low alloy steels for underground storage
Lisa Blanchard,Laurent Briottet,Xavier Campaignolle,Christophe Pommier,Clara Juillet
DOI: https://doi.org/10.1016/j.ijhydene.2024.02.331
IF: 7.2
2024-03-10
International Journal of Hydrogen Energy
Abstract:A key point for the development of a renewable energy economy at a large scale is the possibility to use the current natural gas network and storage capacity to transport and store hydrogen. This study is dedicated to evaluate the integrity of materials used for underground aquifer storage regarding hydrogen embrittlement in a gaseous environment saturated with water vapour and containing few amounts of H 2 S. In this environment, the water vapour content in the gas stored may reach saturation at bottom well pressure and temperature. It is known that the presence of impurities in the gas, such as H 2 O, can promote or inhibit hydrogen embrittlement phenomenon, depending on the nature of the steel. This work investigates mechanical properties of a tempered martensite N80-Q steel, and a ferrite-perlite L360-NB C–Mn steel issued from a completion and a collect tube respectively. The testing environments are NG, NG + H 2 S, NG + 25%H 2 and NG + 25%H 2 + H 2 S saturated in water vapour at 8.5 MPa and room temperature. These environmental conditions aim at replicating the storage service conditions. Fracture toughness and fatigue crack growth properties are assessed. So far, the mechanical behaviour of such steels under hydrogen gas pressure saturated with water vapour and low amount of H 2 S has poorly been addressed. Regarding toughness properties, the two steels present different behaviour: for the L360 NB crack has not propagated for any testing environments, while cracks propagated in all the tests for the N80 Q. Despite this difference, for the two steels, the toughness does not seem to be affected by hydrogen as the results obtained in NG + 25%H 2 + H 2 O and NG + H 2 O are similar. Based on the literature C–Mn steels toughness is affected by the presence of dry hydrogen. Hence, the results presented here show that H 2 O inhibits hydrogen embrittlement as far as toughness is concerned. The L360NB, however, presented a slight decrease in toughness properties with the combination of NG + 25%H 2 + H 2 S + H 2 O. FCG (fatigue crack growth) results, on the opposite, clearly highlight the influence of hydrogen on the mechanical behaviour of the two steels. The FCG rates are faster from a factor five (resp. 10) in NG + 25%H 2 + H 2 O compared to NG + H 2 O for the N80 Q (resp. L360). In this article, toughness and FGC results on the two steels are discussed in terms of microstructure and mechanical loading modes, aiming to quantify and better understand the influence of H 2 O and H 2 S on the sensitivity of low alloy steels to hydrogen embrittlement.
energy & fuels,electrochemistry,chemistry, physical