Abstract:The maglev linear motor has three degrees of motion freedom, which are respectively realized by the thrust force in the x-axis, the levitation force in the z-axis and the torque around the y-axis. Both the thrust force and levitation force can be seen as the sum of the forces on the three windings. The resultant thrust force and resultant levitation force are independently controlled by d-axis current and q-axis current respectively. Thus, the commonly used dq transformation control strategy is suitable for realizing the control of the resultant force, either thrust force and levitation force. However, the forces on the three windings also generate additional torque because they do not pass the mover mass center. To realize the maglev system high-precision control, a maglev linear motor with a new structure is proposed in this paper to decrease this torque. First, the electromagnetic model of the motor can be deduced through the Lorenz force formula. Second, the analytic method and finite element method are used to explore the reason of this additional torque and what factors affect its change trend. Furthermore, a maglev linear motor with a new structure is proposed, with two sets of 90 degrees shifted winding designed on the mover. Under such a structure, the mover position dependent periodic part of the additional torque can be offset. Finally, the theoretical analysis is validated by the simulation result that the additionally generated rotating torque can be offset with little fluctuation in the proposed new-structure maglev linear motor. Moreover, the control system is built in MATLAB/Simulink, which shows that it has small thrust ripple and high-precision performance.

Modeling And Current Control Method For Lvpmm Including Longitudinal End Effects

Robustness Analysis and Enhancement of Deadbeat Predictive Control for Permanent Magnet Linear Synchronous Machines with Asymmetric Model

Improved Analytical Modeling of a Novel Ironless Linear Synchronous Machine With Asymmetrical Double-Layer Winding Topology

An Accurate No-Load Analytical Model of Flat Linear Permanent Magnet Synchronous Machine Accounting for End Effects

Novel Virtual Winding Current Controller for Suppression of Linear Permanent Magnet Machine Electromagnetic Thrust Ripple

A Novel Negative-Sequence Current Injection Method for Reducing LVPMM Electromagnetic Thrust Ripple Considering Static Longitudinal End Effect

Force Ripple Minimization of a Linear Vernier Permanent Magnet Machine for Direct-Drive Servo Applications

Performance Investigation and Improvement of Linear Vernier Permanent Magnet Motor for Servo Application

Thrust Force Ripple Reduction of H‐LVPMM Based on Dynamic Harmonic Current Compensation

Thrust Ripple Optimization and Experiment for a Permanent Magnet Linear Synchronous Motor

A Novel Nonlinear Modeling Method for Permanent-Magnet Synchronous Motors

IPMSM Model Predictive Control in Flux-Weakening Operation Using an Improved Algorithm

Sensorless Control Strategy of Novel Axially Magnetized Vernier Permanent-Magnet Machine

Current Ripple Suppression Of Permanent Magnet Synchronous Linear Motor Considering The Coupling Effect Of D-Q Axis

Symmetrical Components Observer for LPMM Back EMF Based on Negative-Sequence Current Injection

Modified Modeling and Internal Model Control Method of Thrust Ripples in PMLSMs for Ultraprecision Air-Bearing Linear Feed Systems

Design and Optimization of a 12Slot/11pole-Pairs Linear Permanent Magnet Vernier Motor

Comparative Study on a Novel Consequent-Pole Modular Linear Vernier Machine with PMs on Both Mover and Stator Iron Cores

A New Linear Motor Force Ripple Compensation Method Based on Inverse Model Iterative Learning and Robust Disturbance Observer.

Thrust Ripple Reduction of Permanent Magnet Linear Motor for Servo System Based on Sliding Mode Iterative Learning Control with Feedforward Compensation Strategy

Analysis And Design Of A Maglev Permanent Magnet Synchronous Linear Motor To Reduce Additional Torque In Dq Current Control