Assessment and optimization of a decentralized food-waste-to-energy system with anaerobic digestion and CHP for energy utilization

Jingxin Zhang,Danning Gu,Jiaqi Chen,Yiliang He,Yanjun Dai,Kai-Chee Loh,Yen Wah Tong
DOI: https://doi.org/10.1016/j.enconman.2020.113654
IF: 10.4
2021-01-01
Energy Conversion and Management
Abstract:Biogas derived from the decentralized anaerobic digestion (AD) of food waste may be used to generate electrical and thermal energy for nearby residents through combined heat and power generation technology. A mobile food-waste-to-energy system in conjunction with an anaerobic digester and biogas engine was developed for food waste (FW) treatment and energy output. The scale-up was simulated to explore the methane yield and energy flow at different ambient temperatures of 0 degrees C, 10 degrees C, 20 degrees C, 30 degrees C and different feedstock of 200 kg, 500 kg FW. Accordingly, the results demonstrated that the installed system with a 1 m(3) digester had a methane yield of 0.55L CH4/g VS when the feedstock load was 30 kg FW/d and the Organic Load Rate (OLR) was 5.4 g VS/L, while the thermal and electrical efficiencies of this system were 31% and 16%, respectively. The corresponding exhaust gas of the thermal energy from the biogas combustion was recovered by a heat exchanger in order to keep the digester at mesophilic conditions. The simulations carried out on the scale-up systems under loads of 200 kg FW/d and 500 kg FW/d achieved a thermal energy balance at different ambient temperatures of 0 degrees C, 10 degrees C, 20 degrees C and 30 C. Improvements were proposed in the optimized system by optimizing pre-treatment facilities as well as the AD reactor, biogas engine and heat exchanger. The net thermal and electrical energy output of the optimized system at 500 kg FW/d were 175.93kWh and 163.90kWh, respectively. The energy generated by the FW-to-energy system illustrated by the Sankey diagrams depicts that was enough for operation without the need of extra heat and a power supply, moreover, the surplus energy may be utilized for its neighboring communities. In addition, the optimized system under the same OLR were increased by 87% and 135%, regards the thermal and electrical energy outputs, respectively in comparison with the current system.
What problem does this paper attempt to address?