Abstract:The ejector refrigeration cycle (ERC) is often used as the sub-cycle of power and cooling cogeneration systems due to its advantages of simple structure design, few moving parts, less system investment, good stability and reliable operation. Considering the potential of organic Rankine cycle (ORC) in the utilization of low-grade heat, and the advantages of simple structure and many choices for working fluid, a novel power and cooling cogeneration system was designed, based on dual-pressure evaporation ORC (DORC) and ERC. In this system, a common condenser was used by DORC and ERC, and a part of working fluid separated from low-pressure steam generator outlet in DORC was used as the primary flow of ejector to drive ERC. A mathematical model for calculating the thermodynamic and thermoeconomic performances of the system was established. Sensitivity analysis was performed to determine the key parameters of the system, the results showed that the low-pressure evaporation temperature (TLPSG,out), high-pressure evaporation temperature (THP,E), vapor fraction of the low-pressure steam generator outlet (xLPSG,out) and working fluid mass flow ratio of high-pressure stage to low-pressure stage (k) were the four key parameters of the system. Parametric analysis showed that higher TLPSG,out and lower xLPSG,out were beneficial to increase the cooling output and thermal efficiency, while higher THP,E and larger k were helpful to increase the net power output and exergy efficiency. The net power output and exergy efficiency can be optimized by TLPSG,out and xLPSG,out. Using genetic algorithm (GA), multi-objective function optimization was carried out with THP,E, TLPSG,out, xLPSG,out and k as the decision variables. Moreover, the system's adaptability for working fluids R245fa, R236ea, R600, R600a, R601 and R601a was investigated. According to the optimization results, R236ea was the most suitable working fluid. When THP,E was 402.43K, TLPSG,out was 392.42K, xLPSG,out was 0.357 and k was 0.321, the calculated net power output , cooling output, thermal efficiency, exergy efficiency and total cost of unit exergy product (SUCP) were 273.00kW, 121.80kW, 14.52%, 44.03% and 42.62$/MWh, respectively. Exergy analysis was conducted using R236ea as working fluid. The results showed that the two steam generators and condenser were the main components responsible for most of the exergy destruction of the system in both basic case and optimized case. Compared to the basic case, the exergy destruction of the steam generators decreased by about 32.3%, and the total exergy destruction of the system decreased by about 5.0% in optimized case.

Proposal and Thermoeconomic Analysis of a Novel Combined Cooling and Power System Using Carbon Dioxide As the Working Fluid

Performance Analysis and Evaluation of a Supercritical CO2 Rankine Cycle Coupled with an Absorption Refrigeration Cycle

Preliminary Conceptual Exploration about Performance Improvement on Supercritical CO2 Power System Via Integrating with Different Absorption Power Generation Systems

Preliminary Conceptual Design and Thermo-Economic Analysis of a Combined Cooling, Heating and Power System Based on Supercritical Carbon Dioxide Cycle

Thermo-economic Analysis and Optimization of a Novel Carbon Dioxide Based Combined Cooling and Power System

Proposal and Assessment of a Combined Cooling and Power System Based on the Regenerative Supercritical Carbon Dioxide Brayton Cycle Integrated with an Absorption Refrigeration Cycle for Engine Waste Heat Recovery

Thermodynamic Analysis and Comparison Study of Two Novel Combined Cooling and Power Systems with Separators Using CO2-based Mixture for Low Grade Heat Source Recovery

Thermo-economic Analysis and Optimization of a Combined Cooling and Power (CCP) System for Engine Waste Heat Recovery

Analysis of a novel combined cooling and power system by integrating of supercritical CO2 Brayton cycle and transcritical ejector refrigeration cycle

Self-condensing Transcritical CO2 Cogeneration System with Extraction Turbine and Ejector Refrigeration Cycle: A Techno-Economic Assessment Study

Thermodynamic, Economic, Environmental Analysis and Multi-Objective Optimization of a Novel Combined Cooling and Power System for Cascade Utilization of Engine Waste Heat

Thermo-economic-environmental Analysis of an Innovative Combined Cooling and Power System Integrating Solid Oxide Fuel Cell, Supercritical CO2 Cycle, and Ejector Refrigeration Cycle

Thermodynamic Analysis for a Novel Combined Power and Refrigeration Cycle Using Trans-Critical CO2

Preliminary Conceptual Design and Performance Assessment of Combined Heat and Power Systems Based on the Supercritical Carbon Dioxide Power Plant

Exergoeconomic and Exergoenvironmental Analysis of a Novel Power and Cooling Cogeneration System Based on Organic Rankine Cycle and Ejector Refrigeration Cycle

Thermodynamic and Economic Comparison of Novel Parallel and Serial Combined Cooling and Power Systems Based on Sco2 Cycle

A Novel Cooling and Power Cycle Based on the Absorption Power Cycle and Booster-Assisted Ejector Refrigeration Cycle Driven by a Low-Grade Heat Source: Energy, Exergy and Exergoeconomic Analysis

Thermodynamic and thermoeconomic performance analyses and optimization of a novel power and cooling cogeneration system fueled by low-grade waste heat

Thermo-economic analysis of a combined cooling, heating and power system based on carbon dioxide power cycle and absorption chiller for waste heat recovery of gas turbine

Thermodynamic and economic analysis and multi-objective optimization of a novel transcritical CO2 Rankine cycle with an ejector driven by low grade heat source

Preliminary design and part-load performance analysis of a recompression supercritical carbon dioxide cycle combined with a transcritical carbon dioxide cycle