Abstract:A self-powered electromagnetic vibration suppression and absorption system integrated with a magnetorheological damper and a linear motor is designed to attenuate the negative effect of vertical vibration caused by the increased unsprung mass for in-wheel motor electric vehicles in this article. The magnetorheological damper is used as a suspension damper to suppress body vibration, and linear motor is used as a dynamic vibration absorber, namely, linear electromagnetic dynamic vibration absorber, to absorb tire vibration, and regenerates the vibration power to drive the magnetorheological damper, realizing self-power. Based on power flow theory, the power transfer mechanism of the vertical vibration for in-wheel motor electric vehicles and the regeneration potential are analyzed. The negative effect on the dynamic performance of in-wheel motor electric vehicles is analyzed through the root mean square of dynamic responses. Moreover, the specific structure scheme of the self-powered electromagnetic vibration suppression and absorption system is provided. The influence of system mass, stiffness, and damping of the linear electromagnetic dynamic vibration absorber on the dynamic performance is analyzed, and these parameters are optimized by particle swarm optimization. Simulation results show that in comparison with a passive damper, the self-powered electromagnetic vibration suppression and absorption system can reduce the body acceleration by 17.05%, which is better than the magnetorheological damper (10.08%). The self-powered electromagnetic vibration suppression and absorption system increases the tire dynamic load by 5.62%, but it is 8.68% less than the magnetorheological damper. Additionally, the regenerated power can offset the consumed power adequately to realize self-power. Finally, a bench test is conducted to verify the effectiveness and feasibility of the self-powered electromagnetic vibration suppression and absorption system.

Dynamics Analysis of a Novel In-Wheel Powertrain System Combined with Dynamic Vibration Absorber

In-wheel drive system design with dynamic vibration absorption based on the adaptive transmission mechanism

An Integrated Vibration Elimination System with Mechanical-Electrical-Magnetic Coupling Effects for In-Wheel-Motor-Driven Electric Vehicles

Study on Differential Assist Steering System with Double In-Wheel Motors with Intelligent Controller

Vertical Vibration Analysis on Electric Vehicle with Suspended In-Wheel Motor Drives

Vertical vibration control of an in‐wheel motor‐driven electric vehicle using an in‐wheel active vibration system

Comprehensive Analysis and Development of Electric-Drive-Wheel with Idler Gear

Design Optimization of an Integrated E-Type Multilink Suspension Wheel-Side Drive System and Improvement of Vehicle Ride Comfort

Vertical-Longitudinal Coupling Effect Investigation and System Optimization for a Suspension-In-Wheel-Motor System in Electric Vehicle Applications

Electronic Inertia Design for In-Wheel-drive System to Improve Off-Road Dynamic Performance

Structural Topology and Dynamic Response Analysis of an Electric Torque Vectoring Drive-Axle for Electric Vehicles

Mechanism analysis and optimum control of negative airgap eccentricity effect for in-wheel switched reluctance motor driving system

Simulation analysis on vertical vehicle dynamics of three in-wheel motor drive configurations

Design and experimental verification of self-powered electromagnetic vibration suppression and absorption system for in-wheel motor electric vehicles

Vibration and dynamics analysis of electric vehicle drivetrains

Study on a Novel In-Wheel Motor Driving System Driven by Two Permanent Magnet Synchronous Disc Motors

A New Electric Wheel and Optimization on Its Suspension Parameters

Design and optimization of the in-wheel motor driving electric vehicle based on the vibration energy transmission

Design and Simulation of Two Stage Reduction Wheel-Edge Drive System

Evaluation of steering wheel vibration in electric vehicles and application to Dynamic Motor Drive

Integrated design of active suspension parameters for solving negative vibration effects of switched reluctance-in-wheel motor electrical vehicles based on multi-objective particle swarm optimization