Abstract:Since the First Industrial Revolution, traditional fossil energy (coal, petroleum, etc.) has been the most important energy source. However, with social progress and technological development, energy consumption continues to increase. But fossil energy not only has limited reserves, it also causes serious problems (environmental pollution, the greenhouse effect). Therefore, the research and development of clean and sustainable energy are particularly important. One research focus is hydrogen energy. Hydrogen is a promising energy carrier due to its high energy density, clean-burning characteristics, and sustainability. However, the challenges of hydrogen storage and transportation seriously limit its practical application in proton exchange membrane fuel cells. A potential solution is hydrogen storage in the form of a more stable precursor. One such precursor, formic acid, decomposes easily at room temperature in the presence of a catalyst without also producing toxic gases. Effective catalysts for formic acid decomposition (FAD) are key to hydrogen production by this method. In this study, a high-performance palladium (Pd)based catalyst boosted by thin-layered carbon nitride was prepared for formic acid decomposition. First, trimeric thiocyanate was calcined by a one-step method to obtain carbon nitride (C3N4-S) directly, followed by fabrication of a Pd-based FAD catalyst with C3N4-S as support (Pd/C3N4-S). During the pyrolysis of thiocyanuric acid, the overflow of -SH in the precursor had a peeling effect, so that the C3N4 formed as a thin, broken layer with a large specific surface area and pore volume. Because of the improved specific surface area and pore volume and the resulting large number of defect attachment sites, the C3N4-S support effectively dispersed Pd nanoparticles. Furthermore, owing to the electron effect between the support and the metal, the Pd2+ content on the catalyst surface could be adjusted effectively. Pd/C3N4-S showed excellent FAD performance. This catalyst decomposed formic acid into CO2 and H-2 effectively at 30 degrees C. The turnover frequency and mass activity were as high as 2083 h(-1) and 19.52 mol.g(-1).h(-1), respectively. Testing of the gas product by gas chromatography showed that it did not contain CO, indicating that the Pd/C3N4-S catalyst had excellent selectivity. The catalyst also had good stability: its performance decreased by less than 10% after four testing cycles. This study provides a guiding example of development of a formic acid hydrogen production catalyst with high cost performance and a simple preparation method.

Mechanochemically Assisted Fabrication of Ultrafine Pd Nanoparticles on Natural Waste-Derived Nitrogen-Doped Porous Carbon for the Efficient Formic Acid Decomposition

Metal Organic Framework Derived Nitrogen-Doped Carbon Anchored Palladium Nanoparticles for Ambient Temperature Formic Acid Decomposition

Nitrogen‐Decorated Porous Carbon Supported AgPd Nanoparticles for Boosting Hydrogen Generation from Formic Acid

Efficient synthesis of ultrafine Pd nanoparticles on an activated N-doping carbon for the decomposition of formic acid

Efficient Hydrogen Generation from Formic Acid Using AgPd Nanoparticles Immobilized on Carbon Nitride-Functionalized SBA-15

Ultrafine Pd Particles Embedded in Nitrogen-Enriched Mesoporous Carbon for Efficient H-2 Production from Formic Acid Decomposition

Enhanced Photocatalytic Dehydrogenation of Formic Acid over Ultrafine Electron-Deficient Pd Nanoparticles Immobilized on Amine-Functionalized Mesoporous Titanium Dioxide

AuPd Nanoparticles Anchored on Nitrogen-Decorated Carbon Nanosheets with Highly Efficient and Selective Catalysis for the Dehydrogenation of Formic Acid

One stone, three birds strategy for synthesis of N-doped activated carbon-supported surface-enriched and redispersed Pd NPs via plasma for formic acid dehydrogenation

In-situ nitrogen and Cr<sub>2</sub>O<sub>3</sub> co-doped MOF-derived porous carbon supported palladium nanoparticles: A highly effective catalyst towards formic acid dehydrogenation

Pd-Co2P nanoparticles supported on N-doped biomass-based carbon microsheet with excellent catalytic performance for hydrogen evolution from formic acid

High-Performance Palladium-Based Catalyst Boosted by Thin-layered Carbon Nitride for Hydrogen Generation from Formic Acid

Utilizing in situ construction of N-doped hierarchical porous carbon to achieve electronic control of highly dispersed Pd nanoparticles for efficient catalytic hydrogenation of CO 2 to formic acid

Boosting the catalytic activity of pd-nanocatalysts by anchoring transition metal atoms on carbon supports for formic acid dehydrogenation

Renewable biomass-derived, P-doped granular activated carbon for efficient oxidation of 5-hydroxymethylfurfural to 2,5-diformylfuran: Insights into the crucial role of P and N functionality

Surface Interaction Between Pd and Nitrogen Derived from Hyperbranched Polyamide Towards Highly Effective Formic Acid Dehydrogenation

Highly Efficient Dehydrogenation of Formic Acid over Binary Palladium-Phosphorous Alloy Nanoclusters on N-Doped Carbon

Palladium nanoparticles on chitin-derived nitrogen-doped carbon materials for carbon dioxide hydrogenation into formic acid

Synergistic Catalysis of Pd–Ni(OH)2 Hybrid Anchored on Porous Carbon for Hydrogen Evolution from the Dehydrogenation of Formic Acid

In Situ Encapsulated Ultrafine Pd Nanoparticles in Nitrogen-Doped Porous Carbon Derived from Hyper-Crosslinked Polymers Effectively Catalyse Hydrogenation

Efficient decomposition of formic acid into hydrogen on Pd nanoparticles anchored in amine-pyridine polymer networks without extra additives at ambient condition