Abstract:This study explores the application of AncorLam HR (Höganäs, Sweden), a soft magnetic composite material, in the stator core of an axial flux permanent magnet drive motor. Building on previous research that provided mechanical and thermal properties of the material, the focus is on analyzing how the manufacturing process affects the motor core's shape. A bulk prototype was created based on case 3, which demonstrated the least deviation in density and internal stress. The prototypes were produced under the conditions of SPM 7 and 90 °C, and a heat treatment in a nitrogen atmosphere for 1 h, resulting in an average density error of 0.54%, confirming process effectiveness. A microstructural analysis using scanning electron microscopy (SEM) on Sample 2, with the highest density, confirmed consistency between simulation and prototype trends. Electron backscatter diffraction (EBSD) and X-ray diffraction (XRD) analyses revealed that the internal phase structure remained unchanged. Energy-dispersive spectroscopy (EDS) and transmission electron microscopy (TEM) identified the elimination of phosphorus (P) during molding, affecting the insulating layer, a critical factor for SMC materials. In motor simulations and actual measurements, the average torque was recorded as 37.7 N·m and 34.7 N·m at 1500 rpm and 27.7 N·m and 25.1 N·m at 2000 rpm, respectively. The torque comparison observed in the actual measurements compared to the simulation results indicates that the output loss increases in the actual measurements due to the deterioration of the insulation performance judged based on the microstructure evaluation. This study confirms the viability of using AncorLam HR in motor cores for electric vehicles and provides key data for improving the performance.

A Novel Claw Pole Motor with Soft Magnetic Composites

THE MODELING AND CALCULATING ON A NEW TYPE HYBRID CLAW-POLE ALTERNATOR

Design and Fem Analysis of A High Efficiency Axial-Flux Brushless Dc Motor for Flywheel System

Suitable Claw Shape Design for Improving the Magnetic Properties of Forged Claw Pole Parts in Generator

A Hybrid Interior Permanent Magnet Variable Flux Memory Machine Using Two-Part Rotor

Research and Analysis on Design Characteristics of High-Speed Permanent Magnet Claw Pole Motor with Soft Magnetic Composite Cores for Wide Temperature Range

Magnetically soft composites based on iron powders for creating components of a two-stator combined electric motor

Design of the double-stator permanent magnet synchronous starter and generator used in electric vehicles

A Study on Enhancing Axial Flux Motor Efficiency Using Cladding Core Technology

Design Optimization with Outer Rotor Interior Permanent Magnet Synchronous Motor with Hybird Permanent Magnet

Design and Analysis of a Transverse-flux Permanent Magnet Motor With Hybrid Iron-core

Analysis and Cogging Torque Minimization of a Novel Flux Reversal Claw Pole Machine with Soft Magnetic Composite Cores

Study on Magnetic Field Regulation of a Flux-Variable Partitioned Stator Permanent Magnet Claw Pole Motor

Design and Analysis of a Novel Integrated Starter-Generator Based on Brush DC Motor

A Novel Interior Permanent Magnet Synchronous Motor with High Strength Soft Magnetic Composite Powders as Stator-Rotor Material for Electric Vehicle Application

Application of Soft Magnetic Composite in XEV Motor Core Manufacturing: Process Effects and Performance Analysis

Calculation and Analysis of Single Phase Stepper Motor With Claw Poles

Analysis and Improvement of a Hybrid Permanent-Magnet Memory Motor

Design and Analysis of New Modular Stator Hybrid Excitation Synchronous Motor

Design and Analysis of a Doubly Salient Wound Field Starter Generator for Cost-Effective Automobile Application

Characteristics of Soft Magnetic Composites and Application in New Structure Motor