Abstract:Red fluorescent molecules suffer from large, non-radiative internal conversion rates (k(IC)) governed by the energy gap law. To design efficient red thermally activated delayed fluorescence (TADF) emitters for organic light-emitting diodes (OLEDs), a large fluorescence rate (k(F)) as well as a small energy difference between the lowest singlet and triplet excited states (Delta E-ST) is necessary. Herein, we demonstrated that increasing the distance between donor (D) and acceptor (A) in intramolecular-charge-transfer molecules is a promising strategy for simultaneously achieving small Delta E-ST and large k(F). Four D-Ph-A-Ph-D-type molecules with an anthraquinone acceptor, phenyl (Ph) bridge, and various donors were designed, synthesized, and compared with corresponding D-A-D-type molecules. Yellow to red TADF was observed from all of them. The k(F) and Delta E-ST values determined from the measurements of quantum yield and lifetime of the fluorescence and TADF components are in good agreement with those predicted by corrected time-dependent density functional theory and are approximatively proportional to the square of the cosine of the theoretical twisting angles between each subunit. However, the introduction of a Ph-bridge was found to enhance k(F) without increasing Delta E-ST. Molecular simulation revealed a twisting and stretching motion of the NC bond in the D-A-type molecules, which is thought to lower Delta E-ST and k(F) but raise k(IC), that was experimentally confirmed in both solution and doped film. OLEDs containing D-Ph-A-Ph-D-type molecules with diphenylamine and bis(4-biphenyl)amine donors demonstrated maximum external quantum efficiencies of 12.5% and 9.0% with emission peaks at 624 and 637 nm, respectively.

Efficient Red Fluorescent OLEDs Based on Aggregation-Induced Emission Combined with Hybridized Local and Charge Transfer State

Efficient red hybridized local and charge-transfer OLEDs by rational isomer engineering

Efficient red AIEgens based on tetraphenylethene: synthesis, structure, photoluminescence and electroluminescence

A Red Fluorescent Emitter with a Simultaneous Hybrid Local and Charge Transfer Excited State and Aggregation‐Induced Emission for High‐Efficiency, Low Efficiency Roll‐Off OLEDs

High‐Efficiency Deep Red Fluorescent Material with Aggregation Induced Emission and the Application in Organic Light‐Emitting Diodes

Highly Efficient Nondoped Green Organic Light-Emitting Diodes with Combination of High Photoluminescence and High Exciton Utilization

Anthraquinone-Based Intramolecular Charge-Transfer Compounds: Computational Molecular Design, Thermally Activated Delayed Fluorescence, and Highly Efficient Red Electroluminescence

Employing ∼100% Excitons in OLEDs by Utilizing a Fluorescent Molecule with Hybridized Local and Charge‐Transfer Excited State

High-Performance Solution-Processed Red Thermally Activated Delayed Fluorescence OLEDs Employing Aggregation-Induced Emission-Active Triazatruxene-Based Emitters

Administration of the D-A structure and steric hindrance effect to construct efficient red emitters for high-performance OLEDs with low efficiency roll-off

Exciton dynamics of an aggregation-induced delayed fluorescence emitter in non-doped OLEDs and its application as host for high-efficiency red phosphorescent OLEDs

Rational design of efficient orange-red to red thermally activated delayed fluorescence emitters for OLEDs with external quantum efficiency of up to 26.0% and reduced efficiency roll-off

Highly Efficient Red Fluorescent OLEDs Based on Diphenylacridine-Naphthothiadiazole Derivatives with Upper Level Intersystem Crossing

Design of Donor-Acceptor-acceptor (D-a-a')-type Fluorescence Emitters Based on Benzothiadiazole with the Hybridized Local and Charge-Transfer (HLCT) Excited State Feature for Green to Deep-Red Emitting OLEDs

Efficient and Ultra-High Luminance Orange-Red Organic Light Emitting Diode (OLED) Based on Triphenylamine-Benzothiadiazole-phenoxazine Hybrid Molecule with Hybrid Local and Charge-Transfer (HLCT) Characteristic

High-Efficiency Red Organic Light-Emitting Diodes with External Quantum Efficiency Close to 30% Based on a Novel Thermally Activated Delayed Fluorescence Emitter

Efficient Thermally Activated Delayed Fluorescence Materials from Symmetric Anthraquinone Derivatives for High-Performance Red OLEDs

Improving the Efficiency of Red Thermally Activated Delayed Fluorescence Organic Light‐Emitting Diode by Rational Isomer Engineering

Realizing Efficient Red Thermally Activated Delayed Fluorescence Organic Light-Emitting Diodes Using Phenoxazine/phenothiazine-Phenanthrene Hybrids

Efficient red delayed fluorescence molecule based on cyano-substituted 11,12-diphenyldibenzo[ <i>a</i>, <i>c</i>]phenazine acceptor for high-performance organic light-emitting diodes

Simple Aggregation–induced Delayed Fluorescence Materials Based on Anthraquinone Derivatives for Highly Efficient Solution–processed Red OLEDs