Abstract:X-ray diffraction and low-temperature nitrogen adsorption were adopted to investigate the pore structure and crystallization property of the fibers of old newspaper pulp(ONP) and deinking pulp with different deinking modes,and the fractal geometry was used to further analyze the pore structure of the fibers.The results indicate that(1) the BET specific surface area,BJH pore volume and BJH average pore size of the deinking fibers remain almost unchanged after a neutral,alkaline or enzymatic deinking process;(2) the fractal dimensions of the fibers before and after the deinking process are similar,which means that deinking modes have little effect on the pore structure of the fibers;(3) the crystallinity of the fibers decreases to 12.24%,6.12% or 0.77% after a neutral,alkaline or enzymatic deinking process,respectively;(4) the water retention value(WRV) increases after deinking,in an order of alkali deinking>neutral deinking>enzymatic deinking;and(5) after deinking,the beating degree and average length of the fibers slightly decrease while the content of fine fibers increases.

The influence of flow characteristics in deinking cell on fiber loss

The Influence of Flow Characteristics on Flotation Deinking Efficiency in a Deinking Cell

Main Factors Affecting Solid Loss during the Flotation of Mixed Office Waste Pulp

Preliminary research on the deinking ability of column flotation

Study Of The Efficiency Of Flotation Deinking Using A New Type Of Floatation Cell

Development Of A Laboratory Floatation Cell And Its Deinking Efficiency

Effects of Aeration Device and Bubbles Distribution of Flotation Cell on the Deinking Efficiency

Effect of Flotation Parameters on ONP/OMG Deinking Efficiency

Evaluation of the Main Factors Influencing Floatation Deinking Efficiency

Quality of the ONP/OMG Deinked Pulp and the Recycled Water

Parameters Analysis of Column Flotation Deinking Process

Effect Of Fiber Additives On Flow In Journal Bearings

An investigation to deinking technology for MOW

Effects of repulping and flotation methods on deinking efficiency of ONP/OMG recycled pulp

Effects of Different Deinking Methods on Fiber Morphology and Supramolecular Structure of Cellulose

Optimization Of Flotation Parameters In Deinking Of Onp And Omg

Experimental Research on the Hydrodynamic Instability of Fiber Suspensions in Channel Flow

Effect of Fibers on the Flow Property of Turbulent Fiber Suspensions in a Contraction

Effects of Deinking Mode on Pore Structure and Crystallization Property of Recycled Fiber

EFFECT OF REPULPING PARAMETERS ON DEFLAKING OF WASTER PAPER AND IRREVERSIBLE INK REDEPOSITION

Flow and Simulation of Pulp Fiber Suspensions