Abstract:Low-temperature water electrolysis can rapidly produce environmentally sustainable or green hydrogen, and is a prospective means of storing energy from renewable but intermittent power sources, such as wind and solar, in future clean energy infrastructure (1-4). Commercial water electrolysis either use liquid alkaline electrolyte or proton exchange membrane electrolyte (1). The proton exchange membrane water electrolysis (PEMWE) offers more advantages than the alkaline counterpart, such as higher purity of H 2 , lower resistance losses, more compact design, and what the most important is the compatible with the intermittent of the renewable energy (1-2). The grant challenge remaining in PEMWE is the development of the highly active, cost effective and stable catalysts for oxygen evolution reaction (OER), which is very sluggish requiring large amounts of precious metal as the catalysts, such as Ir, Ru and their oxides (1). In PEM water electrolysis cells, the catalysts should have high surface areas and high porosities that exposit sufficient active sites available to the reactants and electrolyte, as well as transferring the bubble out of the catalyst surface to ensure a fast mass transfer (5). Also, the OER is dependent on the inherent conductivity of the catalysts or the supports (1). For example, poor electronic conductivity within the catalyst layer will result in poor lateral conductivity across the catalyst layer, thus catalyst not in the vicinity of the porous transport layer will not participate in the reaction. To enable the widespread penetration of the PEMWE technologies, it is urgently to reduce the Ir loading to the sustainable level (~ 0.3 mg/cm 2 ) compared with the current commercial usage (2-6 mg/cm 2 ). Alternatively, to develop precious metal free catalyst with high efficiency and sustained durability (5). In this presentation, we will describe a method of preparing highly active yet stable synergistic electrocatalysts for oxygen evolution reaction for PEMWE. The new catalysts contain IrCoOx/ RuCoOx cluster and La&Li co-doped Co 3 O 4 fiber which was derived from cobalt zeolitic imidazolate framework as precursor. The OER activities of the catalysts were first tested in O 2 saturated acidic electrolyte by ring disk electrode (RDE), which displayed high mass activity 26-50 times that of commercial Ir and RuO 2 . The catalysts were fabricated into membrane electrode assemble and measured under real PEM water electrolysis condition. The cells demonstrated 2 A/cm 2 @1.76 V @0.25 ± 0.05 mg Ir /cm 2 loading, and negligible degradation after ~250 h chronoamperometric measurements at 2 A/cm 2 (6), which meets the target set by US DOE for OER catalysts for PEMWE. The characterizations of the fresh and post-electrochemical samples were investigated by X-ray photoelectron spectroscopy (XPS), X-ray diffraction (XRD), X-ray absorption near-edge structure (XANES), extended X-ray absorption fine structure (EXAFS), transmission electron microscopy (TEM), Raman spectroscopy and BET surface analysis. We also performed DFT simulation on the OER reaction pathways over Ir and Co sites of different facets parallelly on basis of the TEM results. The result reveals the synergy between Ir/Ru and Co resulting in the enhanced catalytic activities of both IrCoOx /RuCoOx and LaLi@Co 3 O 4 toward OER. Acknowledgments: This work was supported by Overseas Outstanding Youth Fund project, shanghai Jiao Tong university, Shanghai, China; Shanghai Pujiang talent Plan, Shanghai, China; Argonne National Laboratory through Maria Goeppert Mayer Fellowship, US; State Key Laboratory of Metal Matrix Composites, shanghai Jiao Tong university, Shanghai, China. The works performed at Hydrogen research center, shanghai Jiao Tong university, and Argonne National Laboratory’s Center for Nanoscale Materials and Advanced Photo Source. Reference: K. Ayers et al., Annu. Rev. Chem. Biomol. Eng. 10, 219–239 (2019). M. Carmo, D. L. Fritz, J. Mergel, D. Stolten, Int. J. Hydrogen Energy 38, 4901–4934 (2013). M. T. M. Koper, J. Electroanal. Chem. 660, 254–260 (2011). R. D. L. Smith et al., Science 340, 60–63 (2013). Chong et al., Science 380, 609–616 (2023). Chong et al., Adv. Energy Mater. 2023, 2302306.

Shielded Goethite Catalyst That Enables Fast Water Dissociation in Bipolar Membranes

Accelerating water dissociation in bipolar membranes and for electrocatalysis

Design principles for water dissociation catalysts in high-performance bipolar membranes

Optimization of Interfacial OH− Accessibility by Constructing a Delayed–Release Membrane Electrode for Ampere–Level Hydrogen Production

High-performance bipolar membrane for electrochemical water electrolysis

Engineering Bipolar Interfaces for Water Electrolysis Using Earth-Abundant Anodes

Tailoring High-Performance Bipolar Membrane for Durable Pure Water Electrolysis.

Monopolar membrane-assisted acid-alkaline amphoteric water electrolysis towards efficient hydrogen generation

Synergistic Electrocatalysts Impact Efficient and Durable Oxygen Evolution Catalysis for Proton Exchange Membrane Water Splitting

Flexible tungsten disulfide superstructure engineering for efficient alkaline hydrogen evolution in anion exchange membrane water electrolysers

Perovskite‐Based Electrocatalysts for Cost‐Effective Ultrahigh‐Current‐Density Water Splitting in Anion Exchange Membrane Electrolyzer Cell

Anion‐Regulated Hydroxysulfide Monoliths as OER/ORR/HER Electrocatalysts and their Applications in Self‐Powered Electrochemical Water Splitting

Beneficial Use of a Coordination Complex As the Junction Catalyst in a Bipolar Membrane

One-Step Synthesis of Selective Nife-Layered Double Hydroxide Anode Catalyst for Highly Efficient and Stable Anion Exchange Membrane Water Electrolyzers, Operating with Seawater

Interface Engineering of Highly Stable CeO2/CoFe@C Electrocatalysts for Synergistically Boosting Overall Alkaline Water Splitting Performance

Chemically interlocked bipolar membrane achieving stable water dissociation for high output ammonia electrosynthesis

Self-Adaptive Dual-Site Synergy with an Optimized Electronic Configuration for Overall Water Splitting in Acidic Media

Enhanced bipolar membranes for durable ampere-level water electrolysis

Mesoporous cobalt ferrite phosphides/reduced graphene oxide as highly effective electrocatalyst for overall water splitting

Modifying Bipolar Membranes with Palygorskite and FeCl3

Composition and Structure Progress of the Catalytic Interface Layer for Bipolar Membrane