Abstract:Ring-opening polymerization of L- or D-Iactide was realized at 140 degrees C for a period of 7 days in the presence of dihydroxyl poly(ethylene glycol) (PEG), with (M) over bar (n) = 40009 mol(-1), using zinc lactate as initiator. The resulting poly(L-lactide)-PEG- poly(L-lactide) and poly(D-lactide)-PEG- poly(D-lactide) triblock copolymers are water soluble with polylactide (PLA) block length ranging from 11 to 17 units. Both the tube inverting method and rheological measurements were used to evaluate the gelation properties of aqueous solutions containing single copolymers or L/D copolymer pairs. Stereocomplexation between poly(L-lactide) and poly(o-lactide) blocks is observed for mixed solutions. Hydrogel formation is detected in the case of relatively long PLA blocks ((DP) over bar (PLA) = 17), but not for copolymers with shorter PLA blocks ((DP) over bar (PLA) = 11-13) due to partial racemization of L-lactyl units. Racemization is largely reduced when the reaction time is shortened to 1 day. Under these conditions, (DP) over bar (PLA) of 8 is sufficient for the stereocomplexation of PLA-PEG block copolymers, and (DP) over bar (PLA) above 10 leads to the formation of hydrogels of PLA - PEG block copolymers. On the other hand, racemization appears as a general phenomenon in the (co)polymerization of L-lactide with Zn(Lac)(2) as initiator, although it is negligible or undetectable in the case of high molar mass polymers. Therefore, racemization is the limiting factor for the stereocomplexation-induced gelation of water-soluble PLA - PEG block copolymers where the PLA block length generally ranges from 10 to 30. Reaction conditions including initiator, time and temperature should be strictly controlled to minimize racemization. (C) 2010 Society of Chemical Industry

Influence of Racemization on Stereocomplex‐induced Gelation of Water‐soluble Polylactide–poly(ethylene Glycol) Block Copolymers

Competing Stereocomplexation and Homocrystallization of Poly(l-lactic Acid)/poly(d-Lactic Acid) Racemic Mixture: Effects of Miscible Blending with Other Polymers

Synthesis of Cyclic and Linear Block Copolyesters via Ring-opening Copolymerization of epsilon-Caprolatone and L-Lactide Catalyzed by Zinc Complex

Amphiphilic Block Copolymers Based on Methoxy Poly(ethylene Glycol) and Either Crystalline or Amorphous Poly(caprolactone‐b‐lactide): Synthesis, Solid‐state and Aqueous Solution Characterizations

Stereocomplex-Driven Morphological Transition of Coil-Rod-Coil Poly(lactic Acid)-Based Cylindrical Nanoparticles

Effects of Stereocomplexation on the Physicochemical Behavior of Pla/Peg Block Copolymers in Aqueous Solution

In Situ Formation and Gelation Mechanism of Thermoresponsive Stereocomplexed Hydrogels upon Mixing Diblock and Triblock Poly(Lactic Acid)/Poly(Ethylene Glycol) Copolymers.

Synthesis and Gelation Properties of PEG-PLA-PEG Triblock Copolymers Obtained by Coupling Monohydroxylated PEG-PLA with Adipoyl Chloride.

Short Poly(ethylene Glycol) Block Initiation of Poly(l‐lactide) Di‐block Copolymers: a Strategy for Tuning the Degradation of Resorbable Devices

Unique Crystallization Behavior of Poly(l-Lactide)/poly(d-lactide) Stereocomplex Depending on Initial Melt States

Stereoselective Ring‐Opening Polymerization of Racemic Lactide by Racemic Organo‐Catalyst at Room Temperature: Direct Access to Stereocomplex Polylactides

Weak Lewis Pairs As Catalysts for Highly Isoselective Ring-Opening Polymerization of Epimerically Labile Rac-O-carboxyanhydride of Mandelic Acid

Polymorphic homocrystallization and phase behavior of high-molecular-weight Poly(L-lactic acid)/poly(D-lactic acid) racemic mixture with intentionally enhanced stereocomplexation ability via miscible blending

Synthesis and Rheological Properties of Polylactide/poly(ethylene Glycol) Multiblock Copolymers

Stereoselective homo- and co-polymerization of lactides and ε-caprolactone catalysed by highly active racemic zinc(II) pyridyl complexes

Enhanced Crystallization Rate and Mechanical Properties of Poly(l‐lactic Acid) by Stereocomplexation with Four‐armed Poly(ϵ‐caprolactone)‐block‐poly(d‐lactic Acid) Diblock Copolymer

Highly active cobalt(II) and copper(II) complexes supported by aminomethylquinoline mediating stereoselective ring‐opening polymerization of rac‐lactide

Effects of L-lactide and D,L-lactide in poly(lactide-co-glycolide)-poly(ethylene glycol)-poly(lactide-co-glycolide) on the bulk states of triblock copolymers, and their thermogellation and biodegradation in water

Competitive stereocomplexation, homocrystallization, and polymorphic crystalline transition in poly(L-lactic acid)/poly(D-lactic acid) racemic blends: molecular weight effects

Stereocomplexation of High-Molecular-weight Enantiomeric Poly(lactic Acid)s Enhanced by Miscible Polymer Blending with Hydrogen Bond Interactions

Exclusive Stereocomplex Crystallization of Linear and Multiarm Star-Shaped High-Molecular-Weight Stereo Diblock Poly(lactic acid)s.