Abstract:Nanoscale mechanical resonator-based nanoelectromechanical systems have been reported with ultrahigh sensitivity, which are normally acquired from an ultravacuum environment at cryostat temperature. To facilitate their practical applications for gas sensing or bio-detection, it is critical to understand how the fluid (gas or liquid) environment will impact the resonance behaviors of the nanoresonator. This work reports a first-time comprehensive investigation on the influence of the N-2 gaseous environment on the resonance properties of carbon nanotube (CNT)-based mechanical resonator, through a combination of grand canonical Monte Carlo and large-scale molecular dynamics simulations. It is shown that the gaseous environment exerts a significant effect on the resonance properties of the CNT resonator through a dynamic desorption and readsorption process. Under the temperature of 100 K and the pressure of 1 bar, the displacement amplitude of the CNT resonator is found to experience a sharp reduction of about 82% within the first 90 ps vibration in the N-2 gaseous environment. Further, a large initial excitation is found to result in smaller adsorption and a reduced damping effect. For instance, when the excitation velocity amplitude increases from 2 to 8 angstrom/ps, the damping ratio shows more than 40% reduction. It is found that higher pressure leads to a smaller resonance frequency and enhanced damping effect, while higher temperature induces an increase in the resonance frequency but a decrease in the damping ratio. This work shows that the gaseous environment has a marked impact on the vibrational properties of nanoresonators, which should shed light on the application of mechanical nanoresonators in a fluid environment.

Metrological Properties of an Ionization Gauge with Carbon Nanotube Cathode in Different Gases

A Cylindrical Triode Ultrahigh Vacuum Ionization Gauge with a Carbon Nanotube Cathode

Bayard-Alpert Ionization Gauge Using Carbon-Nanotube Cold Cathode

Conventional Triode Ionization Gauge with Carbon Nanotube Cold Electron Emitter

A Low-Vacuum Ionization Gauge With Hfc-Modified Carbon Nanotube Field Emitters

How Gaseous Environment Influences a Carbon Nanotube-Based Mechanical Resonator

A MEMS-Type Hot-cathode Ionization Gauge With Carbon Nanotube-based Electron Emitters

Miniature Cold Cathode Ionization Gauge Based on Composite Films of Carbon Nanotubes and Mgo Nanoparticles

A saddle-field gauge with carbon nanotube field emitters

Cylindrical hot cathode ionisation gauge – Construction and testing

A Novel Gas Field Ionization Ion Source Based on Printed Carbon Nanotubes Thin-Film

Vacuum Measurement Based on Field Emission of CNT Yarn

Study of a low-energy collimated beam electron source and its application in a stable ionisation gauge

Carbon Nanotube Gas Sensor Based on Corona Discharge

Experimental Study and Electric Field Simulation of a UHV Saddle Field Gauge with a CNT Field Emitter

A Novel Gas-Ionization Sensor Based on Aligned Multi-Walled Carbon Nanotubes

A Miniaturized Ionization Vacuum Sensor Based on Thermionic Electron Emission From Carbon Nanotubes

Experimental Study of Carbon Nanotubes Gas Sensor Based on Corona Discharge

Improved Field Emission Properties of MgO‐nanoparticle‐doped Carbon Nanotube Films and Their Application in Miniature Vacuum Gauges

A vacuum sensor using field emitters made by multiwalled carbon nanotube yarns

Fabrication of Carbon-Nanotube Sheet Based Hydrogen Sensor