Mitigating the Noise-Source Coupling Effect in Shear Measurement

Hekun Li,Jun Zhang

DOI: https://doi.org/10.3847/1538-4357/abec6d

IF: 5.521

2021-01-01

The Astrophysical Journal

Abstract:Subpercent level accuracy in shear measurement is required by the Stage-IV weak lensing surveys. One important challenge is suppressing the shear bias on source images of low signal-to-noise ratios (S/N less than or similar to 10). Previously, it has been demonstrated that the shear estimators defined in the Fourier_Quad (FQ) method can achieve subpercent accuracy at the very faint end (S/N less than or similar to 5) through ensemble averaging. Later, it was found that we can approach the minimum statistical error (the Cramer-Rao Bound) by symmetrizing the full probability distribution function (PDF) of the FQ shear estimators (the PDF_SYM approach), instead of taking ensemble averages. Recently, with a large amount of mock galaxy images, we were able to identify some small amount of shear biases in the PDF_SYM approach at the faint end. The multiplicative bias goes up to (1-2) x 10(-2) at S/N less than or similar to 10, and the anisotropy of the point-spread function causes an additive bias that can reach a few times 10(-4). We find that these biases originate from the noise-source coupling in the galaxy power spectrum. It turns out that this problem can be largely fixed by adding additional terms to the FQ shear estimators. The resulting multiplicative and additive biases can be significantly suppressed to the level of 10(-3) and 10(-5), respectively. These corrections substantially extend the available S/N range for accurate shear measurement with the PDF_SYM approach.