Abstract:This paper proposes a fast model predictive control allocation (MPCA) approach to minimize the tire slip power loss on contact patches for distributed drive electric vehicles (DDEV). In this strategy, two assumptions are set up from a practical focus: (1) the vehicle acceleration and yaw rate are measurable by global position system (GPS)/ inertial navigation system (INS) and inertial measurement unit (IMU), respectively; (2) the longitudinal velocity, road adhesion factor, and vehicle yaw rate are arranged to be “already known” by advanced estimators. For the strategy design, a CarSim-embedded driver model and a linear quadratic regulator (LQR) based direct yaw moment controller, are respectively applied to calculate the desired longitudinal traction and yaw moment as a virtual input first. Then, a MPCA method is proposed to reasonably distribute the virtual input among four in-wheel motors in order to optimize the tire slip power loss and vehicle stability performance. To accurately characterize tire slip power loss in MPCA, a tire slip estimator is established for tire slip information acquirement. Moreover, addressing on the heavily computational challenge in MPCA, a modified continuation/generalized minimal residual (C/GMRES) algorithm is employed. Since the traditional C/GMRES algorithm cannot directly solve the inequality constraint problem, the barrier functions are applied for transforming the inequality constraints to equivalent cost. According to Pontryagin’s minimum principle (PMP) conditions, the existence and uniqueness for solution of the modified C/GMRES algorithm are strictly proved. Subsequently, a Karush–Kuhn–Tucker (KKT) condition based approach is developed to fast gain the optimally initial solution in C/GMRES algorithm for extending application. Finally, numerical simulation validations are implemented and demonstrate that the proposed MPCA can ensure the compatibility between the tire slip power loss reduction and vehicle stability in a computationally efficient way.

A Creep Control for Distributed Rear Wheel Drive Bus

A Human-Machine Co-Driven Creep Control for an Electric Bus

Emergency Braking Control Strategy for High Speed Electric Drive Tracked Vehicle

Research on Stability Control Algorithm of Distributed Drive Bus under High-Speed Conditions

Design of an Adaptive Distributed Drive Control Strategy for a Wheel-Side Rear-Drive Electric Bus

Regenerative Braking Control Strategy for Distributed Drive Electric Vehicles Based on Slope and Mass Co-Estimation

An Anti-Slip Control Strategy with Modifying Target and Torque Reallocation for Heavy In-Wheel Motor Vehicle

Variable domain hybrid decision-based friction optimization control for train multi-wheelsets

A Novel Hierarchical Global Chassis Control System for Distributed Electric Vehicles

Torque Adaptive Traction Control for Distributed Drive Electric Vehicle

A review of drive torque distribution control for distributed drive electric vehicles

Constraint Performance Slip Ratio Control for Vehicles with Distributed Electrohydraulic Brake-by-wire System

Driving Torque Coordination Control of Distributed Drive Electric Vehicles

Integrated DYC and ASR Mixed Control of Distributed Drive Electric Vehicle Using Co-Simulation Methodology

Coordinated Longitudinal and Lateral Stability Improvement for Electric Vehicles Based on a Real-Time NMPC Strategy

A fast model predictive control allocation of distributed drive electric vehicles for tire slip energy saving with stability constraints

A Novel Brake Control Strategy For Electric Vehicles Based On Slip Trial Method

Piecewise Integral-Proportional Wheel Slip Control for an In-Wheel Motor Driven Vehicle

Robust Control of Regenerative and Hydraulic Brakes for Enhancing Directional Stability of an Electric Vehicle During Straight-Line Braking

Rule-based torque vectoring distribution strategy combined with slip ratio control to improve the handling stability of distributed drive electric vehicles

A Novel Control Scheme of Propulsion Motor for Integrated Powertrain of Electric Bus