Abstract:The Ni-Fe-based superalloy GH4169 (Inconel718) is widely used for several critical gas-turbine components which are hot forged. Its microstructure and property are sensitive to the parameter adjustment during hot working process. To obtain required low-cycle fatigue and fracture properties, it is essential that the microstructure is controlled during preheating and heat treatment. The evolution of non-uniform microstructure during hot working is more complicated than that of uniform microstructure. On the other hand, various secondary phases can be observed in GH4169 alloy, thus it is important to investigate the effect of secondary phases on the microstructure evolution during forging process. In this work, the mechanisms of non-uniform microstructure evolution in GH4169 alloy were studied by analyzing the evolution of secondary phases, grain boundary misorientation, grain size and interactions of dislocation. It is found that the volume fraction of 8 phase increases with the increasing of temperature and heating time at the lower temperature. While at the higher temperature, it decreases monotonously with the temperature increasing, but increases first and then decreases to stable value with time increasing. The pinning effect of secondary phases in GH4169 alloy can be concluded that the gamma '' phase and 8 phase precipitated within the grains retain movement of dislocation, the 8 phase precipitated at the grain boundary hinders the nucleation and growth of recrystallized grains, and the carbides limits the grain growth. The frequency of low angle grain boundary decreases with temperature and time increasing, and the mobility of low angle grain boundary increases with temperature increasing. The uniformity of microstructure and the size of equaxied subgrain increases with heating temperature and time increasing. Continuous recrystallization of elongated grain occurs at specific conditions. The mechanisms of non-uniform microstructure evolution during heating process can be concluded as sub grain growth, recrystallized grain growth, and anneal twinning nucleation and growth. The recrystallized grains are formed by the growth of subgrains conducted by the rotation of low angle grain boundary and the movement of dislocation. When the grain growth is pinned, the mechanisms for the energy dissipation is the nucleation and growth of anneal twinning. And the growth of anneal twinning promotes the generation of low angle grain boundaries at the tip of partial anneal twinning.

Recrystallization Characterization of FGH96 Superalloy

Recrystallization of the Hot Isostatic Pressed Nickel-Base Superalloy FGH4096. II: Characterization and Application

Dynamic Recrystallization and Grain Refining of Superalloy FGH4096

Mechanisms of Non-Uniform Microstructure Evolution in Gh4169 Alloy During Heating Process

RECRYSTALLIZATION NUCLEATION MECHANISM OF FGH4096 POWDER METALLURGY SUPERALLOY

Recrystallization Process of GH738 Alloy at Different Deformation Conditions

Experimental Investigation on Recrystallization Mechanism of a Ni-base Single Crystal Superalloy

Influence of Deformation Rate on Nucleation and Growth of Recrystallized Grains during Hot Deformation of Nickel-Based Powder Superalloys

Recrystallization of the Hot Isostatic Pressed Nickel-Base Superalloy Fgh4096: I. Microstructure and Mechanism

Experimental Study and Numerical Simulation of Dynamic Recrystallization for a FGH96 Superalloy During Isothermal Compression

A novel recrystallization annealing method to cooperatively control the grain size and phase content for initial aged GH4169 superalloy forging

Effect of Deformation Parameters on Microstructure Evolution of FGH4113A Powder Metallurgy Superalloy

Kinetics and microstructural evolution during recrystallization of a single crystal superalloy

Deformation and microstructural evolution in alloy FGH96 under isothermal forging conditions

Evolution of Interface and Crystal Orientation of Laser Solid Formed Gh4169 Superalloy During Recrystallization

An innovative annealing treatment method and its mechanism to refine deformed mixed grains of initial aged GH4169 superalloy

Simulation of the FGH96 Superalloy Microstructural Changes under Different Deformation Conditions

Role of As-Cast Dendritic Microstructure in Recrystallization of a Ni-based Single Crystal Superalloy

Dynamic Recrystallization of the Hot Isostatically Pressed P/M Superalloy FGH4096 in Hot Working Process

Constitutive Modeling of Dynamic Recrystallization Kinetics and Processing Maps of Solution and Aging FGH96 Superalloy

Normal and abnormal grain growth in a FGH96 superalloy during thermomechanical treatment