Abstract:The new refrigerant R152a (CH3-CHF2) is modelled as a fluid of homonuclear two-centre Lennard-Jones molecules with a point dipole along the axis. This 2CLJD potential has four parameters which were determined by using results of previous and new molecular dynamics simulations for 2CLJD molecules of elongation L* = 0·505 and different reduced dipole moments μ*. For each of these dipole moments zero pressure liquid densities at two temperatures were taken to determine the Lennard-Jones parameters ϵ and σ from a fit to experimental saturated liquid densities. A subsequent comparison of calculated second virial coefficients with experimental values led to the conclusion that μ*2 = 8 in combination with ϵ/k = 119·0K and σ = 3.845 Å is a reasonable choice. Further simulations with those parameters, all performed with vectorized codes on a CYBER 205, gave reasonable predictions of the thermodynamic properties. As the reduced dipole moment μ*2 = 8 corresponds to 2·73 D compared to the experimental value of 2·27 D, the effect of rotating the dipole vector out of the molecular axis was also investigated. It is found that for a dipole vector forming some angle with the molecular axis a smaller value of the dipole moment is required to produce similar thermodynamic properties as for the case when the dipole is along the axis. Spherical harmonic expansion coefficients gu′m of the pair correlation function are given for the model with and without the dipole and also for three different orientations of the dipole vector with respect to the molecular axis.

Electron Scattering Cross Sections of 1,1,1,2-Tetrafluoroethane (R134a)

Electron impact partial ionization cross section and thermal rate coefficients of gaseous refrigerants

Theoretical and experimental study on a novel mixture refrigerant of R161 +R227ea

Cycle performance study of ethyl fluoride in the refrigeration system of HFC-134a

Vapor–liquid Equilibrium of Difluoromethane +1,1,1,2-Tetrafluoroethane Systems over a Temperature Range from 258.15 to 343.15K

Solubility of Refrigerant 1,1,1,2-Tetrafluoroethane in Then,n-Dimethyl Formamide in the Temperature Range from (263.15 to 363.15) K

Experimental Study of Pvtx Properties in the Gas Phase for Binary Mixtures of Dme and Hfc-134a

Vapor–Liquid Equilibria for the Binary Systems Difluoromethane (R32) + Trans-1,1,1,4,4,4-hexafluoro-2-butene (r1336mzz(e)) and Fluoroethane (R161) + Trans-1,1,1,4,4,4-hexafluoro-2-butene (R1336mzz(e))

Gas Phase PVTx Properties for Binary Mixtures of HFC-161 and HFC-134a

Experimental Study on the Influence of Flame Retardants under High-Temperature Conditions on the Flammability of R1234ze(E) and R290

Measurements of the isobaric heat capacity of R1234yf in liquid phase at temperatures from 305 K to 355 K and pressures up to 5 MPa

Electron Collision Cross Sections in Tetrafluoropropene HFO1234ze(E) for Gas Mixtures in Resistive Plate Chambers

Thermal Conductivity of Binary Mixtures of 1,1,1,2-Tetrafluoroethane(R-134a), 2,3,3,3-Tetrafluoropropene (R-1234yf), and trans-1,3,3,3-Tetrafluoropropene (R-1234ze(E)) Refrigerants

An International Standard Formulation for the Thermodynamic Properties of 1,1,1,2‐Tetrafluoroethane (HFC‐134a) for Temperatures from 170 K to 455 K and Pressures up to 70 MPa

Solubility of Refrigerant Trifluoromethane in N, N-Dimethyl Formamide in the Temperature Range from 283.15 K to 363.15 K

Surface Tension for the 1,1,1-Trifluoroethane (R-143A)+1,1,1,2-tetrafluoroethane (R-134A) System

Thermal conductivity measurements for trans-1,3,3,3-Tetrafluoropropene (R1234ze(E)) in liquid phase

Pulsed townsend electron and ion swarm parameter measurements of the trigger RPC standard mixture

Elastic and Inelastic Electron Scattering Cross Sections of Trichlorofluoromethane

Molecular dynamics studies for the new refrigerant R152a with simple model potentials

An International Standard Formulation for the Thermodynamic Properties of 1,1,1-Trifluoroethane (HFC-143a) for Temperatures From 161 to 450 K and Pressures to 50 MPa