Selective catalytic reduction of NO(x)with NH(3)over TiO(2)supported metal sulfate catalysts preparedviaa sol-gel protocol

Yanke Yu,Jiali Zhang,Changwei Chen,Mudi Ma,Chi He,Jifa Miao,Huirong Li,Jinsheng Chen
DOI: https://doi.org/10.1039/d0nj02647f
IF: 3.3
2020-01-01
New Journal of Chemistry
Abstract:Due to the presence of SO(2)in flue gas, SCR catalysts with high SO(2)tolerance are desperately required. However, except vanadium-based catalysts, most metal oxide catalysts exhibit low SO(2)tolerance. In this research study, CuSO4/TiO2, Fe-2(SO4)(3)/TiO2, MnSO4/TiO2, Ce(SO4)(2)/TiO(2)and CoSO4/TiO(2)catalysts were preparedviaa sol-gel protocol and used in the NH3-SCR reaction. Low-temperature N-2-sorption, XRD, FT-IR, XPS, H-2-TPR, NH3-TPD andin situDRIFTS were used to characterize the physicochemical properties of the prepared catalysts. The presence of SO(2)had little influence on the activity of all metal sulfate catalyst samples. CuSO4/TiO(2)showed the highest SCR activity and apparent activation energy among the metal sulfate catalysts following the sequence of CuSO4/TiO2< Fe-2(SO4)(3)/TiO2< MnSO4/TiO2< Ce(SO4)(2)/TiO2< CoSO4/TiO2. Characterization results indicated that the amount of acid sites was the main factor that influenced the catalytic activity of the metal sulfate catalysts. The NH3-SCR reaction of all metal sulfate catalysts followed the Eley-Rideal mechanism: NH(3)was first adsorbed at the surface acid sites (Lewis and Bronsted acid sites), and then it reacted with gaseous NO and O(2)to form N(2)and H2O. The metal sulfate catalysts, especially CuSO4/TiO2, should be a promising candidate for vanadium-based SCR catalysts for NO reduction.
What problem does this paper attempt to address?