High-speed air-blowing impacting method——a renovated method for batch preparation of pharmaceutical co-crystals
Bing-yang SUN,Ru-fang PENG,Hua LIANG,Shi-jin CHU,Jin ZUO,Bo LU
DOI: https://doi.org/10.13637/j.issn.1009-6094.2017.03.052
2017-01-01
Abstract:The paper is aimed at introducing a renovated method we have developed for batch preparation of pharmaceutical cocrystals.The so-called air-flow impacting method is referred to as a continuous synthesis process of the four theophylline pharmaceutical co-crystals,that is,the theophylline-cinnamic acid,theophylline-salicylic acid,theophylline-glutaric acid and the theophylline-benzoic acid.The above said four theophylline pharmaceutical co-crystals have usually been prepared in the following steps:First of all,it is necessary to mix the theophylline (THL) and salicylic acid (SAA),the glutaric acid (GLA),cinnamic acid (CA),benzoic acid (BA) in a molar ratio between 1 to 1.And,then,the mixture can be transferred into an impacting chamber at a rate of 1.5 kg/min (90 kg/h).In so doing,it is also necessary to accelerate the materials to a very high velocity (300 m/s) in the compressed air (1.5 MPa),and,next,the intermediate materials can be collected through a short-time reaction (an interval of about 30 seconds).Afterwards,the AS-prepared four pharmaceutical co-crystals can be examined and characterized by using Fourier transform infrared (FT-IR) spectrometry,X-ray diffraction (XRD),the differential thermal analysis (DTA) and the electronic scanning microscopy (ESM).The DTA testing resuits help to find in nice correlation between the co-crystal melting temperature and the melting points of the corresponding pure theophylline.Furthermore,we have also measured the solubility curves of the four pharmaceutical co-crystals in phosphate buffer of pH 7.4 (Na2HPO4 + KH2PO4) at the temperature of 30 ℃.Thus,the absorbance of a known concentration of the theophylline can be worked out at the given λ max (270 nm) by using a UV-1800 spectrophotometer,with the absorbance values being plotted against a series of standard solutions in preparing the calibration curve of concentration vs.intensity.What is more,in order to determine the equilibrium solubility,it is also necessary to add an excess amount of each co-crystal to 20 mL of phosphate buffer in the volumetric flasks,which can be stirred up at 50 r/min with a magnetic stirrer at the temperature of 30 ℃.And,later,through a 48 h reaction,the suspension solution can be filtered (0.45 μm,Whatman) and properly diluted,with the absorbance being measured at the given λ max (270 nm).Therefore,the results of the experiments indicate that the four co-crystals tend to have exhibited higher apparent solubility and faster dissolution rate as compared with the original theophylline.In conclusion,the proposed method can be used for pharmaceutical production.