Deactivation Mechanism of Solid Acid Catalyst for Alkylation of Thiophenic Sulfur Compounds with Olefins

罗国华,徐新,单希林,佟泽民,彭少逸

DOI: https://doi.org/10.3321/j.issn:0253-9837.2004.08.012

IF: 16.5

2004-01-01

Chinese Journal of Catalysis

Abstract:Over 90% sulfur compounds in FCC gasoline are thiophenic sulfur compounds and most of them exist in the high-boiling fraction. A desulfurization method was proposed for the removal of sulfur compounds from FCC gasoline by alkylation of thiophenic sulfur compounds with olefins over solid acid catalyst, and the obtained alkylated thiophenes were concentrated in the heavy fraction of FCC gasoline by rectification. In this paper, the AlCl3 catalyst supported on a macroporous sulfonic resin CT175 was used for the alkylation of thiophenic sulfur compounds with olefins, and the deactivation mechanism of the catalyst was studied by means of GC-FPD and GC-MS. The AlCl3-CT175 resin catalyst showed excellent initial catalytic activity for the alkylation of thiophenic sulfur compounds with olefins in FCC gasoline of boiling range of 60 similar to 150 degreesC, but the catalyst activity decreased greatly after reaction for 20 h. However, when the liquid feedstock comprising benzene, model sulfur compounds (such as thiophene, 2-methylthiophene and 2-ethylthiophene) and isobutylene was used, the AlCl3-CT175 resin catalyst showed high stability in the 1 160 h-duration test, and the conversion of thiophene was higher than 95% under WHSV 2.33 h(-1), isobutylene volume velocity of 7.5 ml/min and reaction temperature of 65 degreesC. Meanwhile, the effects of diolefin type (such as isoprene, cyclopentadiene and 5-methyl-1 3-cyclopentadiene) and content on the stability of the AlCl3-CT175 resin catalyst were further investigated, and the catalyst activity decreased rapidly owing to the fact that the diolefins in the feedstock were polymerized on the catalyst surface.