Abstract:The present experimental study addresses the flow of a Yield Stress Fluid with some elasticity (Carbopol gel) in a square duct. The behaviour of two fluids with lower and higher yield stress is investigated at multiple Reynolds numbers $Re^* \in$ (1, 200) and Bingham numbers $Bi \in$ (0.01, 0.35). A secondary flow consisting of eight vortices is observed to recirculate the fluid from the corners to the core. Their extent and intensity grows with increasing $Re^*$. The second objective of this study is to explore the change in flow in the presence of particles. Almost neutrally-buoyant finite-size spherical particles with duct height, $2H$, to particle diameter, $d_p$, ratio of 12 are used at two volume fractions $\phi$ = 5 and 10\%. Particle Tracking Velocimetry (PTV) is used to measure the velocity of these refractive-index-matched spheres, and PIV to extract the fluid velocity. Simple shadowgraphy is also used for qualitatively visualising the development of the particle distribution along the streamwise direction. The particle distribution pattern changes from being concentrated at the four corners, at low flow rates, to being focussed along a diffused ring between the center and the corners, at high flow rates. The presence of particles induces streamwise and wall-normal velocity fluctuations in the fluid phase; however, the primary Reynolds shear stress is still very small compared to turbulent flows. The size of the plug in the particle-laden cases appears to be smaller than the corresponding single phase cases. Similar to Newtonian fluids, the friction factor increases due to the presence of particles, almost independently of the suspending fluid matrix. Interestingly, predictions based on an increased effective suspension viscosity agrees quite well with the experimental friction factor for the concentrations used in this study.

Structured Spheres Generated by an In-Fibre Fluid Instability

Synthesis of scalable micro-spheres by Plateau-Rayleigh instability

In-fiber Fabrication of Size-Controllable Structured Particles

In-Fiber Structured Particles and Filament Arrays from the Perspective of Fluid Instabilities

Fluidization of the Spherocylindrical Particles: Comparison of Multi-Sphere and Bond-Sphere Models

Particle size selection in capillary instability of locally heated co-axial fiber

On Coherent Structures in Gas–solid Fluidization

Polymeric Microparticles Generated via Confinement‐Free Fluid Instability

Coherent Structures in the Mixing Layers of a Non-Newtonian Fluid

On Instability of Dilute Fiber Suspensions in an Axisymmetric Taylor-Couette Flow

Dynamics of Finite-Size Spheroids in Turbulent Flow: the Roles of Flow Structures and Particle Boundary Layers

Exploration of In-Fiber Nanostructures from Capillary Instability

Hydrodynamic Instability of Semi-concentration Fiber Suspensions Between Two Rotating Coaxial Cylinders

Non-axisymmetric Instability in the Taylor-Couette Flow of Fiber Suspension

Modeling of Completely Deformed Complexity-free Anisotropic Fluid Spheres

Fluid dynamic instabilities: theory and application to pattern forming in complex media

Emergence of lobed wakes during the sedimentation of spheres in viscoelastic fluids

Packings of 3D stars: Stability and structure

Spongy all-in-liquid materials by in-situ formation of emulsions at oil-water interfaces

Persistent structures in a 3D dynamical system with solid and fluid regions

Finite-size spherical particles in a square duct flow of an elastoviscoplastic fluid: an experimental study