Abstract:Coastal global navigation satellite system (GNSS) stations equipped with a standard geodetic receiver and antenna enable water level measurement using the GNSS interferometry reflectometry (GNSS-IR) technique. By using GNSS-IR, the vertical distance between the antenna and the reflector surface (e.g., water surface) can be obtained in the vertical (height) reference frame. In this study, the signal-to-noise ratio (SNR) data from four selected stations over three months are used for this purpose. We determined the predominant multipath frequency in SNR data that is obtained using Lomb–Scargle periodogram (LSP) method. The obtained sea surface heights (SSH) are assessed using tide gauge observations regarding accuracy and correlation coefficients. In this study, we investigated daily and hourly GNSS observations and used single frequencies of GPS (L1, L2 and L5), GLONASS (L1 and L2), Galileo (L1, L5, L6, L7 and L8), and BeiDou (L2 and L7) signals to estimate the SSH. The results show that the optimal signals for extracting the SSH are the L1 signal for the GPS, Galileo, and GLONASS systems and the L2 signal for the BeiDou system. The accuracy and correlation parameters for the optimal GPS signal in the daily mode are 2 cm and 0.87, respectively. The same parameters for the optimal GLONASS signal are 4 cm and 0.91. However, the obtained accuracy and correlation coefficients using the best Galileo and BeiDou signals are reduced, i.e., 4 cm and 0.88 using Galileo and 12 cm and 0.52 by employing the Galileo signals, respectively. Our results also show that the GPS L1 signal is more consistent with the tide gauge data. In the following, using the time series derived from the L1 signal and tide gauge readings, the tidal frequencies are extracted and compared using the Least Square Harmonic Estimation (LS-HE) approach. The findings demonstrate that 145 significant tidal frequencies can be extracted using the GNSS-IR time series. The existence of an acceptable correlation between the tidal frequencies of the GNSS-IR and the tide gauge time series indicates the usefulness of the GNSS-IR time series for tide studies. From our results, we can conclude that the GNSS-IR technique can be applied in coastal locations alongside tide gauge measurements for a variety of purposes.

Validation and Analysis of TPXO over Offshore Areas Using GPS-IR Technology

A study on oil and gas exploration using tidal gravity

Comparation and Analysis of World Ocean Tides

A Study Of Real-Time Tide Measurement

Improvement of the Accuracy of Ocean Tide Model Based on the Offshore Continuous Gravity Data with Atomic Gravimeter

A study on the quality of GNSS signals for extracting the sea level height and tidal frequencies utilizing the GNSS-IR approach

Assessment of sub-daily ocean tide loading errors and mitigation of their propagation in multi-GNSS position time series

A High Precision Tidal Model Based on Multisource Tidal Harmonic Constants for Offshore China

Global Positioning System Interferometric Reflectometry for Accurate Tide Gauge Measurement: Insights from South Beach, Oregon, United States

The Impact of Different Ocean Tide Loading Models on GNSS Estimated Zenith Tropospheric Delay Using Precise Point Positioning Technique

Evaluation of Real-Time PPP-Based Tide Measurement Using IGS Real-Time Service

GPS Signal to Noise Ratio Analysis and Using for Real-Time Tide Monitoring

GNSS-IR Inshore Tide Measurement Based on Low-cost Chipset

A Novel Method to Improve the Estimation of Ocean Tide Loading Displacements for K1 and K2 Components with GPS Observations.

The Latest Application to Determine Tide Height in A Large-Scale Sea Using Shipborne Gps Based on Precise Point Positioning and Egm 2008

Utilizing Normal Time-Frequency Transform-Assisted GNSS-R to Retrieve Sea Surface Height

Evaluation of Ocean Tide Loading Effects on GPS-estimated Precipitable Water Vapour in Turkey

Benefits of tidal admittance functions for refining GNSS-observed solar and lunisolar tidal constituents

Comparative analysis of GNSS-IR sea level retrieval methods

Ocean Tide Loading Correction for InSAR Measurements: Comparison of Different Ocean Tide Models

Research on Sea Surface Height Measurement Based on GNSS-IR Dual Frequency Data Fusion