Micrographic Properties of Composite Coatings Prepared on TA2 Substrate by Hot-Dipping in Al–Si Alloy and Using Micro-Arc Oxidation Technologies (MAO)

Shaopeng Wang,Lian Zhou,Changjiu Li,Zhengxian Li,Hongzhan Li,Lijing Yang

DOI: https://doi.org/10.3390/coatings10040374

IF: 3.236

2020-01-01

Coatings

Abstract:A composite coating composed of intermetallic compounds, Al–Si alloys, and an oxide ceramic layer was prepared on TA2 substrate by hot-dipping Al–Si alloy and micro-arc oxidation (MAO) methods. The microstructure and composition distribution of the resulting hot-dipped Al–Si alloy layer and MAO-caused ceramic layer were studied by scanning electron microscope (SEM) and energy dispersive spectrum (EDS). In addition, the phase composition of the diffusion layer obtained by the Al–Si alloy hot-dipping procedure was investigated by electron backscattered diffraction (EBSD), and the phase structure of the MAO-treated layer was studied by X-ray diffraction (XRD) analysis and X-ray photoelectron spectroscopy (XPS). The MAO method can make the hot-dipped Al–Si alloy layer in-situ oxidized to form a ceramic layer. Finally, a three-layer composite coating composed of a diffusion layer formed by the Ti–Al–Si interdiffusion, an Al–Si alloy layer and a ceramic layer was prepared on TA2 substrate. Compared with TA2 substrate, the TA2 sample with a three-layer composite coating has larger friction coefficient and less abrasion loss. The three-layer composite coating can significantly improve the wear resistance of TA2. A technical composite method was developed to the low cost in-situ growth of alumina-based ceramic wear-resistant coatings on TA2 substrate.