Abstract:We propose a novel laser configuration that can output 3.5-μm nanosecond laser pulses based on a simple and monolithic fiber structure. Cascade-gain-switching, which converts the wavelength of nanosecond pulses from 1.55 μm to 3.5 μm by two successive gain-switching processes. Instead of using expensive pump sources at special wavelengths and bulky active or passive modulation elements for Q-switching or mode-locking, the cascade gain-switching only requires the pumping of an electric-modulated 1.55-μm pulsed laser and two continuous-wave (CW) 975-nm laser diodes. They are all standard products for fiber optic communication applications, which can greatly lower the cost of mid-infrared laser pulse generation. To investigate the feasibility of this configuration, we numerically simulated the cascade-gain-switching processes by comprehensive rate-equation models. In single-shot regime, for stable 3.5-μm pulsed lasing, the CW 975-nm pump should be turned on at least ∼ 500 μs ahead of the 1.55-μm pulsed pump. It shows that the pulse width of the 1.55-μm pump has major impact on the temporal shape of the intermediate 1.97-μm pulse while has neglected influence on the generated 3.5-μm pulse. On the other hand, increasing the CW pump power can significantly improve the output peak power and shorten the pulse when the pump power is less than ∼ 4 W. In the repetitive-pulse regime, we found the 3.5-μm pulse train can be stably outputted when the repetition rate is <= 100 kHz. As the repetition rate increases, the duration of reaching the stable operation increases. When the repetition rate is large than 100 kHz, the stable operation cannot be established because the rate of consuming the population on the 4I11/2 level of Er 3+ ions is faster than the rate of building the population.

Generation of Nanosecond 2.65 Μm Pulses and Pulse Narrowing in Fiber-Bulk Ho3+:YAG Laser Pumped Gain-Switched Cr2+:CdSe Laser

Generation of 3 mJ, 44 fs, 2.5 micrometer pulses from a single-stage Cr2+:ZnSe amplifier

Compact Passively Q-switched Green Laser with Periodically Poled MgO:LiNbO 3

Sub-nanosecond Nd:YAG/Cr4+:YAG Crystal Laser Operating at 0.9 Μm

4.5-Ns Pulse Generation at a 500-Khz Repetition Rate from a Short-Cavity Acoustooptically Q-switched Nd:YVO4 Laser

Few ns Pulse Duration of Gain-Switched Ho:YAG Laser Pumped by an Active Q-Switched Tm:YLF Laser

Nanosecond Pulse Generation at 2.7 Μm from a Passively Q-Switched Er:Y2O 3 Ceramic Laser

Generation of 70-fs pulses at 2.86 μm from a mid-infrared fiber laser

Investigation of a Gain-Switched Cr2+: ZnSe Laser Pumped by an Acousto-Optic Q-switched Ho : YAG Laser

High-peak-power and narrow-linewidth Q-switched Ho:YAG laser in-band pumped at 1931 nm

Dioder-pumped Self-Q-switched Cr 4+ , Nd 3+ : YAG Laser with Amplifier

Diode-Pumped Nanosecond Pulsed Laser With Pulse-Transmission-Mode Q-Switch

2.09 µm high-gain, high-energy sub-nanosecond laser amplification system and its application to a millijoule-level mid-infrared ZnGeP2 optical parametric generator.

Cascade-gain-switching for generating 3 . 5-μ m nanosecond pulses from low-cost monolithic fiber lasers

Efficient Long Wave IR Laser from Ho：YAG 2 Μm Pumped ZnGeP2 Optical Parametric Oscillator

Generation of 22.7-Fs 2.8-Nj Pulses from an Erbium-Doped All-Fiber Laser Via Single-Stage Soliton Compression

A 12 Mj 11 Ns Spectrally Narrow Fiber Amplifier with A Pulsed Pump

Generation of 8-fs and 13-nJ pulse from a Yb-fiber system with nonlinear-pulse-compression

Direct Generation of 148 nm and 44.6 fs Pulses in an Erbium-Doped Fiber Laser

Generation of femtosecond pulses based on efficient frequency doubling of erbium fiber oscillator-amplifier laser

A Compact YAG/Nd:YAG/Cr:YAG Passively Q -Switched Pulse Burst Laser Pumped by 885 Nm Laser Diode