Abstract:SUMMARY When a seismic wave propagates in a fluid-saturated porous medium, a relative movement forms between the solid and the fluid and induces an electric current due to the electronic double layer. As a result, two kinds of seismoelectric coupling responses are generated in this procedure: the localized electric/magnetic field and interfacial electromagnetic wavefield. One important potential application of these two seismoelectric conversions is used for measuring formation P and S waves in well logging. Considering that the strong collar wave seriously affects the velocity measurements of formation P and S waves in current acoustic logging while drilling (LWD), the seismoelectric LWD method, which combines seismoelectric conversion and acoustic LWD technique, was suggested to be a novel method in oil and gas exploration. The collar wave cannot induce any seismoelectric signal on the metal collar since there is no double layer formed on a metal surface. In this paper, acoustic and seismoelectric LWD measurements are conducted in the laboratory. We build a scaled multipole acoustic LWD tool to conduct acoustic measurements in a water tank and a sandstone borehole model. We also build a multipole seismoelectric LWD tool and record the seismoelectric signals induced with the same acoustic source. Then, we compare the recorded acoustic and seismoelectric signals by using the experimental data. The result indicates that the apparent velocities of seismoelectric signals are equal to the formation P- and S-wave velocities and the collar waves do not induce any visible electric signal in the full waveforms. We further analyse the mechanism of seismoelectric LWD by a quantitative comparison of the amplitudes between the inner collar wave and outer collar wave. The results show that the amplitude of outer collar wave decreases significantly when it radiates out of the tool, so that the seismoelectric signals induced by collar waves are too weak to be distinguished in the full waveforms of seismoelectric LWD measurements. Thus, the formation P- and S-wave velocities are detected accurately from the recorded seismoelectric LWD data. These results verify the feasibility of the seismoelectric LWD method for measuring acoustic velocities of the borehole formation.

Influence of salinity interface on seismoelectric logging wave field

A Study on the Influence of Salinity Interfaces on Borehole Seismoelectric Wavefields

Interface Detection of Near-Borehole Stratified Formation under Different Permeabilities Based on Seismoelectric Logs: A Finite-Difference Modeling

Study on Numeric Simulation of Complex Resistivity Logging

Experimental Measurements of Seismoelectric Signals in Borehole Models

Simulation of the Borehole Quasistatic Electric Field Excited by the Acoustic Wave During Logging While Drilling Due to Electrokinetic Effect

Experimental Studies on Seismoelectric Prospecting Measurements in a Fluid Saturated Rock Sample

Theoretical study and tests on geophone-limestone coupling effect

The Theoretical Simulation of the Seismoelectric Logging While Drilling Based on an Elastic Formation Model

Electrokinetic experimental studies in borehole model II : localized and radiated seismoelectric field

Theoretical Simulation of Electroacoustic Borehole Logging in a Fluid-Saturated Porous Formation

Finite-difference modeling of seismoelectric logs

Theoretical Study on the Amplitude Ratio of the Seismoelectric Field to the Stoneley Wave and the Formation Tortuosity Estimation from Seismoelectric Logs

Influence of Drill Collar Wave on Multipolar Source Seismoelectric Logging While Drilling

Experimental studies on the mechanism of seismoelectric logging while drilling with multipole source

Finite-difference Modeling of the Electroseismic Logging in a Fluid-Saturated Porous Formation

Numerical Analysis of Seismoelectric Conversion in Stratified Low-Permeability Porous Rocks

Experimental study of multipole seismoelectric logging while drilling

Theoretical Simulation of the Multipole Seismoelectric Logging While Drilling

Electrokinetic experimental studies in borehole model I : the evaluation of rock permeability

Study of the Seismoelectric Effect in Saturated Porous Media Using a Bundle of Capillary Tubes Model