Abstract:BackgroundBisphenol compounds are non-persistent environmental endocrine disruptors and frequently detected in drinking water systems, indicating potential human health risks through drinking water. ObjectiveTo establish and optimize a simultaneous determination method for 16 BPs in drinking water by online solid-phase extraction-ultra high-performance liquid chromatography-triple quadrupole mass spectrometry, in order to efficiently monitoring BPs in drinking water. MethodsCandidate online solid-phase extraction conditions, chromatographic columns, mobile phase systems, mass spectrometry parameters, and other conditions were compared by chromatographic peaks of BPs, and processing conditions such as water sample preservation and pretreatment were optimized. The pH level of drinking water samples was adjusted and solid particles were removed. After extraction and purification by an online solid-phase extraction system, samples were detected by ultra-high performance liquid chromatography tandem mass spectrometry and quantified by isotope internal standard method. The proposed method was verified by pure water and terminal tap water, and evaluated by spiked recovery rate and relative standard deviation. Eighty-eight tap water samples from different regions of local pipeline network were collected for method application. ResultsFor the 16 BPs, the calibration curves showed good linearity between 1.0 and 75 ng·L−1 and the correlation coefficients were greater than 0.995. The detection limit of the method was less than 0.30 ng·L−1, and the quantification limit of the method was less than 1.0 ng·L−1. When the spiked concentrations for the 16 BPs were 5.0, 15, and 40 ng·L−1, the average spiked recovery rates of the test substances were between (100 ± 10)%, and the relative standard deviations were all below 10%. In the method application to the local terminal water samples, the positive rates of bisphenol S (BPS), bisphenol A (BPA), and bisphenol AF (BPAF) were as high as 93.2%, 77.3%, and 29.5%, respectively. The concentrations of BPS were from not detected (N.D.) to 37.8 ng·L−1, and the concentrations of BPA were from N.D. to 52.0 ng·L−1. ConclusionThe method using an online solid-phase extraction system is established, featuring simple pre-treatment, small sample volume, high degree of automation, low detection limit, and good accuracy and precision. This method can be applied to the quantitative monitoring of 16 BPs at ng·L−1 level in drinking water.

Rapid Analysis of Bisphenol A in Food Packaging Materials by Desorption Corona Beam Ionization Tandem Mass Spectrometry

Amperometric determination of bisphenol A in milk using ionic liquid-carbon nanotube composite electrode

Determination of 16 Bisphenols in Drinking Water by Online Solid-Phase Extraction-Ultra High-Performance Liquid Chromatography Tandem Mass Spectrometry

Automated On-Line Liquid Chromatography–photodiode Array–mass Spectrometry Method with Dilution Line for the Determination of Bisphenol A and 4-Octylphenol in Serum

Simple high‐performance liquid chromatography‐ultraviolet method for simultaneous separation and detection of 14 bisphenol pollutants in building materials

Dispersive micro solid phase extraction (DMSPE) using polymer anion exchange (PAX) as the sorbent followed by UPLC-MS/MS for the rapid determination of four bisphenols in commercial edible oils

Determination of bisphenol analogues in food-contact plastics using diode array detector, charged aerosol detector and evaporative light-scattering detector

Determination and Occurrence of Bisphenol A and Thirteen Structural Analogs in Soil

Rapid Determination of Aldehydes in Food by High-Throughput Reactive Paper Spray Ionization Mass Spectrometry

An ultra-sensitive monoclonal antibody-based enzyme-linked immunosobent assay for dibutyl phthalate in human urinary

Determination of bisphenol-type contaminants from food packaging materials in aqueous foods by solid-phase microextraction-high-performance liquid chromatography

Determination Of Bisphenol A Based On Biotin-Avidin Enzyme Linked Immunosorbent Assay

Determination of the occurrence of and exposure to bisphenol A and its analogues in carbonated beverages and canned tuna using liquid chromatography - tandem mass spectrometry

Analysis of bisphenols in soft drinks by on-line solid phase extraction fast liquid chromatography-tandem mass spectrometry

Recent advances and progress in the detection of bisphenol A

Boron nitride quantum dots-enhanced laser desorption/ionization mass spectrometry analysis and imaging of bisphenol A

Simultaneous fluorescence determination of bisphenol A and its halogenated analogs based on a molecularly imprinted paper-based analytical device and a segment detection strategy

Fluorimetric Determination of Trace Bisphenol-A Based on Its Oxidative Reaction with Fenton-Like Reagent As Oxidant

Determination of bisphenol a in mineral water by membrane-protected micro-solid phase extraction followed by high-performance liquid chromatography diode array detector

Highly Specific and Sensitive Detection of Bisphenol A in Water Samples Using an Enzyme-Linked Immunosorbent Assay Employing a Novel Synthetic Antigen

Surface Imprinted Superparamagnetic Nanoparticles for Rapid and Efficient Extraction of Bisphenol A from Water Samples