Abstract:Passive isolation has been widely accepted as an effective means for the protection of structures against seismic hazards. The isolation bearings, typically placed at the base of the structure, increase the flexibility of the structure and shift its fundamental frequency away from the dominant frequency of seismic excitations, resulting in significantly reduced interstory drifts and floor accelerations. During severe earthquakes, the performance of passive isolation systems is usually achieved at the expense of having large base displacements. Alternatively, active isolation combines isolation bearings with adaptive actuators to effectively mitigate the base displacements, while maintaining reasonable interstory drifts and floor accelerations. Despite successfully theoretical proof documented in previous studies, most experimental implementations only verified active isolation with unit-axial actuators under unidirectional excitations. Earthquakes are intrinsically multidimensional, resulting in out-of-plane responses such as torsional responses. Therefore, the focus of this paper is the development and experimental verification of active isolation strategies for multistory buildings subjected to bidirectional earthquake loadings. First, a model building is designed to be dynamically similar to a representative full-scale structure. The selected isolation bearings feature low friction and high vertical stiffness, providing stable behavior. In the context of the multidimensional response control, three custom-manufactured and appropriately scaled actuators are employed to mitigate both in-plane and out-of-plane responses. In addition, the structure is subjected to multi-directional earthquake ground motion. To obtain a high-fidelity model of the active isolation systems, the authors propose a hybrid identification approach, which combines the advantages of the lumped mass model and nonparametric methods. Control-structure interaction is also included in the identified model to further enhance the control authority. By employing the H-2/LQG control algorithm, the controllers for the hydraulic actuators are shown to offer high performance and good robustness. Active isolation is found to possess the ability to reduce base displacements and produce comparable accelerations and interstory drifts to passive isolation. The proposed active isolation strategies are validated experimentally for a six-story building tested on the six-degree-of-freedom shake table in the Smart Structures Technology Laboratory at the University of Illinois at Urbana-Champaign. Copyright (c) 2013 John Wiley & Sons, Ltd.

Periodic Material-Based Passive Control Systems for Engineering Structures

Analysis and Design of One Dimensional Periodic Foundations for Seismic Base Isolation of Structures

A Periodic Foundation with Rotational Oscillators for Extremely Low-Frequency Seismic Isolation: Analysis and Experimental Verification

Seismic Isolation of Small Modular Reactors Using Metamaterials

Analytical Research on a Locally Resonant Periodic Foundation for Mitigating Structure-Borne Vibrations from Subway

Analytical Research on the Mitigation of Structure-Borne Vibrations from Subways Using Locally Resonant Periodic Foundations

Dynamics and Active Control of Largely Deflected Active Structures Using the Finite Element Technique

Distributed Modal Identification and Vibration Control of Continua: Piezoelectric Finite Element Formulation and Analysis

Periodic foundations for seismic base isolation of small modular reactors

Design and Optimization of Periodic Structure Mechanical Filter in Suppression of Foundation Resonances

Periodic foundation piles for the seismic protection of structures

An innovative pendulum-type column-in-column (PCIC) system for structural vibration control induced by seismic ground excitations

Distributed Vibration Control and Identification of Coupled Elastic Piezoelectric Systems - Finite-Element Formulation and Applications

Design of Passive Systems for Control of Inelastic Structures

A novel vibration barrier for low-frequency surface waves in the ground

Recent Advances on Vibration Control of Structures Under Dynamic Loading

Seismic isolation of buildings using composite foundations based on metamaterials

Semi-Active Control for Benchmark Building Using Innovative TMD with MRE Isolators

Seismic isolation of buildings with sliding concave foundation (SCF)

Shielding buildings from surface waves with “Seismic Metastructures”

Multiaxial Active Isolation for Seismic Protection of Buildings