CuMn 2 O 4 Spinel Nanoflakes for Amperometric Detection of Hydrogen Peroxide
Yuan Gao,Bo Li,Zhuyan Zhang,Xianfa Zhang,Zhaopeng Deng,Lihua Huo,Shan Gao
DOI: https://doi.org/10.1021/acsanm.1c00898
IF: 6.14
2021-07-02
ACS Applied Nano Materials
Abstract:The rapid and accurate detection of hydrogen peroxide (H<sub>2</sub>O<sub>2</sub>) has recently been a fascinating research topic in electrochemical sensing. Herein, spinel CuMn<sub>2</sub>O<sub>4</sub> nanoflakes were synthesized through coprecipitation and pyrolysis methods and then drop-coated onto the surface of a bare glassy carbon electrode (GCE), successfully generating an enzymatic-free electrochemical sensor (CuMn<sub>2</sub>O<sub>4</sub>/GCE) for good amperometric detection ability of H<sub>2</sub>O<sub>2</sub>. In comparison with the reported spinel AB<sub>2</sub>O<sub>4</sub>-based electrocatalysts in a phosphate buffer solution, the CuMn<sub>2</sub>O<sub>4</sub>/GCE sensor exhibits a high sensitivity of 3.420 A M<sup>–1</sup> cm<sup>–2</sup> and a low detection limit of 12 nM. This excellent sensing performance is mainly derived from the inherent porous structure and the large electrochemical active area of spinel CuMn<sub>2</sub>O<sub>4</sub> nanoflakes, as well as the synergistic effect between Cu and Mn that facilitates electron transfer and increases active sites. Especially, the high contents of Cu<sup>+</sup> and Mn<sup>3+</sup> ions in the nanocatalyst are useful for promoting the capture and reduction of trace H<sub>2</sub>O<sub>2</sub>. In addition, the CuMn<sub>2</sub>O<sub>4</sub>/GCE sensor presents a satisfactory recovery in monitoring H<sub>2</sub>O<sub>2</sub> derived from rat serum, commercial milk, and disinfectors, indicating its potential applications in related environmental, food, and biological fields.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsanm.1c00898?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsanm.1c00898</a>.Instruments; ESR spectrum of CuMn<sub>2</sub>O<sub>4</sub>; XRD patterns of CuO and Mn<sub>2</sub>O<sub>3</sub> samples; XPS full spectra of CuO, Mn<sub>2</sub>O<sub>3</sub>, and CuMn<sub>2</sub>O<sub>4</sub>; high-resolution XPS spectra of CuO and Mn<sub>2</sub>O<sub>3</sub> samples; SEM images of products calcined at different temperatures and their electrochemical H<sub>2</sub>O<sub>2</sub> sensing performance; TEM images and XRD pattern of precursor; typical current–time curves of CuMn<sub>2</sub>O<sub>4</sub>/GCE with consecutive injection of 0.05 mM H<sub>2</sub>O<sub>2</sub> into 0.05 M PBS at different pH values; <i>i</i>–<i>t</i> curves of CuO/GCE and Mn<sub>2</sub>O<sub>3</sub>/GCE with consecutive injection of H<sub>2</sub>O<sub>2</sub> into 0.05 M PBS and their respective fitting curves; Table S1, two reference CuMn<sub>2</sub>O<sub>4</sub> composites by doping CuO and MnO<sub>2</sub> of corresponding synthesis and characterizations and their electrochemical H<sub>2</sub>O<sub>2</sub> sensing performance; Table S2, TEM images and XPS spectra of CuMn<sub>2</sub>O<sub>4</sub> nanomaterial after stability tests (<a class="ext-link" href="/doi/suppl/10.1021/acsanm.1c00898/suppl_file/an1c00898_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.
materials science, multidisciplinary,nanoscience & nanotechnology