Efficient conversion of cellulose to 5-hydroxymethylfurfural using a bifunctional hydrophobic SBA-15 catalyst: The effects of hydrophobicity, morphology and acidity
Yu Yin,Yabo Qi,Chunhui Ma,Wei Li,Sha Luo,Shouxin Liu
DOI: https://doi.org/10.1016/j.fuproc.2023.107752
IF: 8.129
2023-06-01
Fuel Processing Technology
Abstract:Owing to the negative impact of water on catalyst activity, and the consequent side reactions, the hydrophobicity and acidity of the catalyst are important factors in the conversion of cellulose to 5-hydroxymethylfurfural in an aqueous solvent. In the present study, we prepared SBA-15 catalysts comprising hydrophobic methoxy groups, phosphotungstic acid as Lewis acid groups, and -SO3H Brønsted acid groups. The introduction of methoxy groups increased the contact angle of the catalyst from 57.42 to 87.80° and changed its morphology from stubby short rods to long curved sticks. The maximum 5-hydroxymethylfurfural yield (61.24%) was obtained using 2SBA-15-SO3H, which comprised 237.31 μmol·g−1 of the Brønsted acid and 14.44 μmol·g−1 of the Lewis acid and had a contact angle of 75.93°. The low yields of levulinic acid and formic acid (below 10%) confirmed the resistance of such SBA-15 catalysts to water. Furthermore, adequate hydrophobicity facilitated glucose isomerization, whereas the catalyst morphology, which tended to comprise short rods, improved the fructose dehydration rate. Density functional theory analysis of the acidity sites route revealed a 3-DG pathway for 1,4,5,6-tetrahydroxy-hexan-2-one generation with Lewis acid sites, and a free energy of 0.13 eV, paralleled by glucose isomerization to fructose through a 1,2-enediol.
energy & fuels,engineering, chemical,chemistry, applied