Abstract:One of the emerging and environmentally friendly technologies is the photoelectrochemical generation of green hydrogen; however, the cheap cost of production and the need for customizing photoelectrode properties are thought to be the main obstacles to the widespread adoption of this technology. The primary players in hydrogen production by photoelectrochemical (PEC) water splitting, which is becoming more common on a worldwide basis, are solar renewable energy and widely available metal oxide based PEC electrodes. This study attempts to prepare nanoparticulate and nanorod-arrayed films to better understand how nanomorphology can impact structural, optical, and PEC hydrogen production efficiency, as well as electrode stability. Chemical bath deposition (CBD) and spray pyrolysis are used to create ZnO nanostructured photoelectrodes. Various characterization methods are used to investigate morphologies, structures, elemental analysis, and optical characteristics. The crystallite size of the wurtzite hexagonal nanorod arrayed film was 100.8 nm for the (002) orientation, while the crystallite size of nanoparticulate ZnO was 42.1 nm for the favored (101) orientation. The lowest dislocation values for (101) nanoparticulate orientation and (002) nanorod orientation are 5.6 × 10−4 and 1.0 × 10−4 dislocation/nm2, respectively. By changing the surface morphology from nanoparticulate to hexagonal nanorod arrangement, the band gap is decreased to 2.99 eV. Under white and monochromatic light irradiation, the PEC generation of H2 is investigated using the proposed photoelectrodes. The solar-to-hydrogen conversion rate of ZnO nanorod-arrayed electrodes was 3.72% and 3.12%, respectively, under 390 and 405 nm monochromatic light, which is higher than previously reported values for other ZnO nanostructures. The output H2 generation rates for white light and 390 nm monochromatic illuminations were 28.43 and 26.11 mmol.h−1cm−2, respectively. The nanorod-arrayed photoelectrode retains 96.6% of its original photocurrent after 10 reusability cycles, compared to 87.4% for the nanoparticulate ZnO photoelectrode. The computation of conversion efficiencies, H2 output rates, Tafel slope, and corrosion current, as well as the application of low-cost design methods for the photoelectrodes, show how the nanorod-arrayed morphology offers low-cost, high-quality PEC performance and durability.

Deposition of a ZnO Nanolayer on TiO2Nanorods Nanoarrays with Tailored Thickness Towards Boosted Photoelectrochemical Hydrogen Production Activity

Porous TiO2 Nanotubes with Spatially Separated Platinum and CoOx Cocatalysts Produced by Atomic Layer Deposition for Photocatalytic Hydrogen Production

Single-crystal TiO 2 /srtio 3 Core–shell Heterostructured Nanowire Arrays for Enhanced Photoelectrochemical Performance

Nickel Hydroxide Decorated Hydrogenated Zinc Oxide Nanorod Arrays with Enhanced Photoelectrochemical Performance

ALD-grown Oxide Protective Layers on Ta3N5–Cu2O N–p Nanoarray Heterojunction for Improved Photoelectrochemical Water Splitting

Enhanced charge separation of NiO/ZnO P-N heterojunction nanorod arrays for photoelectrochemical water splitting

Hot electron assisted photoelectrochemical water splitting from Au-decorated ZnO@TiO2 nanorods array

ZnO nanorod arrays for photoelectrochemical cells.

Hydrogenated TiO2/ZnO Heterojunction Nanorod Arrays with Enhanced Performance for Photoelectrochemical Water Splitting

Core-shell hetero-phase reduced Ti–Ni–O nanotubes photoanode with enhanced optical absorption and charge transport for boosted photoelectrochemical water splitting

Protected Hematite Nanorod Arrays with Molecular Complex Co-Catalyst for Efficient and Stable Photoelectrochemical Water Oxidation: Protected Hematite Nanorod Arrays with Molecular Complex Co-Catalyst for Efficient and Stable Photoelectrochemical Water Oxidation

Photoelectrochemical Green Hydrogen Production Utilizing ZnO Nanostructured Photoelectrodes

Enhanced photoactivity and stability of carbon and nitrogen co-treated ZnO nanorod arrays for photoelectrochemical water splitting

Facile Synthesis of a Porous ZnO Nanorod Array with Enhanced Photocatalysis for Photoelectrochemical Water Splitting Application.

Surface Plasmon-Driven Photoelectrochemical Water Splitting of Aligned ZnO Nanorod Arrays Decorated with Loading-Controllable Au Nanoparticles

Construction of CdS@ZnO Core–shell Nanorod Arrays by Atomic Layer Deposition for Efficient Photoelectrochemical H2 Evolution

Sb-Doped SnO2 Nanorods Underlayer Effect to the α-Fe2 O3 Nanorods Sheathed with TiO2 for Enhanced Photoelectrochemical Water Splitting

PbO-sensitized ZnO Nanorod Arrays for Enhanced Visible-Light-driven Photoelectrochemical Performance

Hematite Nanorod Arrays Top-Decorated with an MIL-101 Layer for Photoelectrochemical Water Oxidation.

Enhanced photoelectrochemical water splitting by a 3D hierarchical sea urchin-like structure: ZnO nanorod arrays on TiO 2 hollow hemisphere

Conformal Deposition of Atomic TiO2 Layer on Chalcogenide Nanorod with Excellent Activity and Durability Towards Solar H2 Generation