Abstract:The lunar surface exhibits noticeable variations in photometric properties across different regions, influenced by their specific compositional and physical characteristics. These variations are particularly pronounced at the millimeter to centimeter scale. In this study, we propose a feature subspace-based sample selection method to identify Chang'E-4 Visible Near-infrared Imaging Spectrometer (CE-4 VNIS) in situ observations that share similar photometric properties at the centimeter scale. By constructing a feature subspace through principal component transformation, the CE-4 VNIS observation sites with comparable surface photometric properties are able to be selected from a series of observations. The selection results demonstrate that the majority of observation sites are covered by the lunar regolith, with a few exceptions consisting of rocks, soil bulk, shadows, and rough surfaces. These observations should be excluded from the photometric correction process during phase function fitting. Analyzing the photometric performance of the VNIS data with lunar regolith reveals that reflectance decreases as the phase angle increases below 80°, while above 80°, reflectance increases with increasing phase angle. This phenomenon is likely attributed to stronger forward scattering. Thus, a second-order polynomial is employed to fit the phase function for VNIS data. Consequently, a photometric model is developed for lunar regolith observed by CE-4 VNIS, incorporating the fitted phase function. Experimental results demonstrate reduced differences among observations with varying phase angles, and the corrected VNIS spectra exhibit a phase-reddening effect. These findings validate the effectiveness of the proposed model. A comparison between the corrected data with and without sample selection reveals a 33% decrease in mean standard deviation for VIS/NIR bands and a 19% decrease for SWIR bands in the corrected spectra after sample selection. These results indicate the potential applicability of our method for future VNIS observations, enabling the acquisition of photometrically consistent data.

Data Processing Pipelines for Lunar-based Ultraviolet Telescope

Data Processing Pipeline for Pointing Observations of Lunar-based Ultraviolet Telescope

Astrometric Support for the Lunar-based Ultraviolet Telescope

LUT: A Lunar-Based Ultraviolet Telescope

Data Processing Pipeline for the Earth 2.0 Mission

Photometric Calibration of the Lunar-based Ultraviolet Telescope for Its First Six Months of Operation on the Lunar Surface

Calibration and Validation of a Multi-Beam LiDAR Onboard China Chang’e Lunar Probe for Landing Obstacle Avoidance

The Data Processing of the LAMOST Medium-Resolution Spectral Survey of Galactic Nebulae (LAMOST MRS-N Pipeline)

Optimizing Image Processing for Modern Wide Field Surveys: Enhanced Data Management Based on the LSST Science Pipelines

An Automated Pipeline for Ultra-Violet Imaging Telescope (UVIT)

Illumination Robust Landing Point Visual Localization for Lunar Lander with High-resolution Map Generation

Capstone address Introduction to processing and visualization of Chang'e-1 Lunar exploration data

High frequency Lunar Penetrating Radar quality control, editing and processing of Chang'E-4 lunar mission

Sample Data Selection Based on the Feature Subspace for Photometric Correction of the Chang'E-4 in Situ Observations

The Lobster Eye Imager for Astronomy Onboard the SATech-01 Satellite

Opto-mechanisms Design of Extreme-Ultraviolet Camera Onboard Chang E Lunar Lander

The data processing pipeline for the MUSE instrument

Development and Calibration of the Moon-based EUV Camera for Chang'e-3

High-resolution terrain imager development and performance evaluation for lunar exploration

Study on the storage, processing and preparation of lunar samples returned by the Chang?E-5mission

Data processing pipeline for Tianlai experiment