Abstract:The prime objective of this work is to deal with the kinematics of spatial hybrid manipulators. In this direction, in 1955, Denavit and Hartenberg proposed a consistent and concise method, known as D-H parameters method, to deal with kinematics of open serial chains. From literature review, it is found that D-H parameter method is widely used to model manipulators consisting of lower pairs. However, the method leads to ambiguities when applied to closed-loop, tree-like and hybrid manipulators. Furthermore, in the dearth of any direct method to model closed-loop, tree-like and hybrid manipulators, revisions of this method have been proposed from time-to-time by different researchers. One such kind of revision using the concept of dummy frames has successfully been proposed and implemented by the authors on spatial hybrid manipulators. In that work, authors have addressed the orientational inconsistency of the D-H parameter method, restricted to body-attached frames only. In the current work, the condition of body-attached frames is relaxed and spatial frame attachment is considered to derive the kinematic model of a 7-degree of freedom spatial hybrid robotic arm, along with the development of closed-loop constraints. The validation of the new kinematic model has been performed with the help of a prototype of this 7-degree of freedom arm, which is being developed at Council of Scientific & Industrial Research–Central Scientific Instruments Organisation Chandigarh to aid the surgeon during a medical surgical task. Furthermore, the developed kinematic model is used to develop the first column of the Jacobian matrix, which helps in providing the estimate of the tip velocity of the 7-degree of freedom manipulator when the first joint velocity is known.

Kinematic Design of A Generalized Double Parallelogram Based Remote Center-Of-Motion Mechanism for Minimally Invasive Surgical Robot

Kinematic Design of a 2DoFs Remote Center of Motion Mechanism for Minimally Invasive Surgical Robot

Kinematic Analysis of A New Hybrid Surgical Robot

Design of a 1R1T planar mechanism with remote center of motion

Design and Kinematic Optimization of a Two Degrees-of-Freedom Planar Remote Center of Motion Mechanism for Minimally Invasive Surgery Manipulators

Design and Validation of A Novel Planar 2R1T Remote Center-of-motion Mechanism Composing of Dual-Triangular and Straight-Line Linkages

Configuration and Kinematic Analysis of a Novel Hybrid Surgical Robot with a Ball Joint

A new circular-guided remote center of motion mechanism for assistive surgical robots

Design and Analysis of a Spatial 2R1T Remote Center of Motion Mechanism for a Subretinal Surgical Robot

Optimal Design of a Novel Spherical Scissor Linkage Remote Center of Motion Mechanism for Medical Robotics

Kinematic Design of a New Four Degree-of-Freedom Parallel Robot for Knee Rehabilitation

Development of a redundant anthropomorphic hydraulically actuated manipulator with a roll-pitch-yaw spherical wrist

Development of a 2-DOF Singularity-Free Spherical Parallel Remote Center of Motion Mechanism With Extensive Range of Motion

A Controller to Impose a RCM for Hands-on Robotic-Assisted Minimally Invasive Surgery

Optimization design of a parallel surgical robot with remote center of motion

Kinematic Optimization of a Continuum Surgical Manipulator

Conceptual design and dimensional synthesis of a novel parallel mechanism for lower-limb rehabilitation

Complete Kinematics/Dynamics Modeling and Performance Analysis of a Novel SCARA Parallel Manipulator Based on Screw Theory

Kinematic modeling of a 7-degree of freedom spatial hybrid manipulator for medical surgery

Manipulability Optimization Control of a Serial Redundant Robot for Robot-assisted Minimally Invasive Surgery

Kinematic and dynamic analysis of a 3-DOF parallel mechanism