Abstract:To study the effect of SiO2 on the physicochemical characteristic of modified biochar, bio-chars were obtained at 600℃in a vertical furnace from a pyrolysis of rice straw, cotton stalk, and rice husk. Bio-chars were activated at different temperatures (400, 600, 800, and 1 000℃) in a gaseous NH3 and/or CO2 atmosphere. The variation of chemical properties, the CO2 adsorption capacities, and the physicochemical properties linked with an ash analysis of different raw chars and modified chars were investigated. An X-ray fluorescence (EARGE Ⅲ, EDAX Inc.) and an ion chromatograph (ICS-90, Dionex) were used according to the national standard of GB/T1574 to analyze the ash composition of pyrolytic biochars. The content of SiO2 in rice husk char (87.47%) was the highest among the studied samples, followed by rice straw and cotton stalk chars, which were 51.99%and 18.21%, respectively. However, according to the proximate analysis of biomass raw materials, the proportion of ash in rice straw and rice husk was about 2-3 times of that of cotton stalk, therefore, the amount of SiO2 retained in rice husk and rice straw was nearly 15 times and 4-5 times of that in cotton stalk, respectively. The production and modification of biomass chars were carried out in a self-designed vertical furnace reaction system which included two parts: A gas generating zone and a modification reaction zone. The modification reaction zone mainly consisted of a stainless steel reactor (inner diameter 38 mm, outer diameter 40mm, and height 600 mm) and a temperature programmed furnace.A Fourier transform infrared spectrum analyzer (VERTEX70, Bruker) was used to analyze the variation of chemical properties and surface functional groups of biochars before and after NH3 modification at different temperatures. And the Fourier transform infrared spectra of the corresponding biomass raw materials linked with a proximate and ultimate analysis were also presented to compare with that of chars and modified chars. The results showed that in the NH3 atmosphere, a certain amount of nitrogen had been introduced onto the surface of chars, but the amount of N-containing functional groups that was introduced into rice straw chars or rice husk chars were obviously lower than that of cotton stalk chars which may be caused by the large amount of SiO2 that remained in the ash of rice straw and rice husk. The bond energy of Si-O was considerable high, which usually cracks above 1 400℃ and is very difficult to react with the free radical groups such like –NH2 and –NH under an NH3 atmosphere. Since there is a large amount of Si-O function group on the surface of rice straw or rice husk chars, it will hinder the reactions between –NH2, -NH and other radical groups and chars, which will reduce the total modification efficiency of pyrolytic chars. The CO2 adsorption capacities of biochars before and after modification were investigated by an automatic adsorption instrument (ASAP2020, Micromeritics) at room temperature. Experimental results showed that the positive influence of CO2 on pore structure evolution and the introduction of N-containing function groups into char structure may be weakened by SiO2. Bio-chars derived from cotton stalk which were modified under a CO2 atmosphere showed the best CO2 adsorption capacities among all the modification methods and different feedstock. It indicated that modified bio-chars with lower SiO2 content showed better CO2 adsorption performance.

Highly Efficient Utilization of Rice Husk Char to Prepare Carbon Adsorbent and Calcium Silicate

A New Method of Comprehensive Utilization of Rice Husk

A Sustainable Route For The Preparation Of Activated Carbon And Silica From Rice Husk Ash

Comprehensive Utilization of Rice Husk to Prepare Xylose, Capacitance Carbon and Calcium Silicate Whiskers

Rice Husk Waste-Derived Super-Biochar with the Max Surface Area and Philic-CO2 Textural Structure: Boosting Effect and Mechanism of Post-Desilication

Sustainable utilization of rice husk waste for preparation of ordered nanostructured mesoporous silica and mesoporous carbon: Characterization and adsorption performance

Simultaneous Preparation of Silica and Activated Carbon from Rice Husk Ash

Upgrading the rice husk char obtained by flash pyrolysis for the production of amorphous silica and high quality activated carbon

Effect of Rice Husk Ash Addition on Co2 Capture Behavior of Calcium-Based Sorbent During Calcium Looping Cycle

Co-Producing Active Carbons and Sodium Silicate from Pyrolyzed Rice Husk by CO<sub>2</sub> Activation Coupled with NaOH Solution Boiling

Influence of Silica on Physicochemical Characteristic of Modified Bio-Chars

Effect of pyrolysis temperature on Si release of alkali-enhanced Si-rich biochar and plant response

Kinetic study on the preparation of silica from rice husk under various pretreatments

From Typical Silicon-Rich Biomass to Porous Carbon-Zeolite Composite: A Sustainable Approach for Efficient Adsorption of CO2.

A Study on the Consecutive Preparation of Silica Powders and Active Carbon from Rice Husk Ash

Simultaneous Synthesis of Silica Polymorphs and Activated Carbon from Rice Husk

Enhancement of Reactivity in Li4SiO4-based Sorbents from the Nano-Sized Rice Husk Ash for High-Temperature CO2 Capture

In Situ Preparation of Biochar Coated Silica Material from Rice Husk

A Green Route for Pyrolysis Poly-Generation of Typical High Ash Biomass, Rice Husk: Effects on Simultaneous Production of Carbonic Oxide-Rich Syngas, Phenol-Abundant Bio-Oil, High-Adsorption Porous Carbon and Amorphous Silicon Dioxide

Self-template mechanism of “selective silicon dissolution” for the construction of functional rice husk biochar

Effect of Washing Pretreatment with Aqueous Fraction of Bio-Oil on Pyrolysis Characteristic of Rice Husk and Preparation of Amorphous Silica