Abstract:In this paper, numerical simulations of single-jet impingement cooling and double-jet impingement cooling processes of heated L-shaped steel are carried out using the VOF model. The SIMPLEC pressure–velocity coupling algorithm and realizable k-ε model are used for the solution. The effects of jet position, water flow, and jet distance in the single-jet condition are analyzed in the simulations. The distributions of impact pressure, turbulence kinetic energy, and Nusselt number were obtained, as well as the variation of the peak values of these three factors with the jet position, water flow, and jet distance. The water flow rate is 3–11 L/min, and the jet distance is 5–25 cm. The effect of the distance between the two nozzles on the jet cooling uniformity under the dual jet condition was also analyzed. The distance between the two nozzles was 15–45 mm. The results showed that the variation of water flow rate had a greater effect on the ability of jet cooling compared with the jet position and jet distance, and the heat transfer efficiency also increased gradually with the increase of water flow, but the increased rate of heat transfer efficiency decreased gradually. When the flow rate increased from 3 to 11 L/min, the maximum instantaneous cooling rates at 1/4 of the thickness of the short side upper side, long side upper side, short side lower side, and long side lower side positions increased by 38.9%, 48.5%, 48.2%, and 32.9%, respectively. To ensure that the jet does not shift, the jet distance should be less than or equal to 10 cm. In the case of the double jet, the nozzle distance is 1.5 cm, and the cooling uniformity of the cooling area between the two nozzles is better. The peak Nusselt number in the cooling area of each part under the double jet cooling condition increased by 5%, 9.4%, 10.2%, and 13.3%, respectively, compared with the single jet.

Numerical investigation of flow field and heat transfer characteristics in a latticework duct with jet cooling structures

LAMINAR FLOW AND HEAT TRANSFER IN THE DEVELOPING REGION OF HELICAL SQUARE DUCTS

Flow and Heat Transfer Characteristics in a Microchannel with a Circular Synthetic Jet

Thermal performance in latticework ducts with various endwall shapes for aero-craft turbine cooling

Detailed Heat Transfer Measurements of Curved Fin Channels

Influence of corrugated jet plates on internal heat transfer and flow dynamics of double-wall cooling: experimental-numerical approach

Effect of the Nozzle Geometry on Flow Field and Heat Transfer in Annular Jet Impingement

Numerical Study on the Effect of a Lobed Nozzle on the Flow Characteristics of Submerged Exhaust

Numerical Simulation of the Flow and Heat Transfer Characteristics of Sweeping and Direct Jets on a Flat Plate with Film Holes

Numerical Simulation of Heat Transfer Enhancement by Jet-Induced Longitudinal Vortices

Numerical simulation of single-jet impact cooling and double-jet impact cooling of hot-rolled L-shaped steel based on multiphase flow model

Numerical Study of Heat Transfer in a Lattice Matrix with Varying the Crossing Angle

Numerical Study of the Flow and Heat Transfer of a Rectangular-tube Turbulent Impinging Jet Flow

Numerical Study on the Effect of Jet Spacing on the Swirl Flow and Heat Transfer in the Turbine Airfoil Leading Edge Region

Numerical Investigation and Parameter Sensitivity Analysis on Flow and Heat Transfer Performance of Jet Array Impingement Cooling in a Quasi-Leading-Edge Channel

Numerical simulation and experimental study of strip steel jet cooling

Latticework (Vortex) Cooling Effectiveness: Rotating Channel Experiments

Experimental and Numerical Investigations of Extended Jet Effects on Multiple-Jet Impingement Heat Transfer Characteristics

Numerical investigation of laminar natural convective heat transfer from a horizontal triangular cylinder to its concentric cylindrical enclosure

Experimental and Numerical Analysis on Heat Transfer Performance of Slug Flow in Rectangular Microchannel

Effects of Flow Ratio of Transverse Jet on Flow and Heat Transfer : A LBE Study